We have investigated the polarization dependence of the near-band-edge photoluminescence and photoreflectance spectra in nonpolar (A-plane) ZnO films under strong biaxial compressive strain. We show that anisotropic strain and the orientation of the nonpolar plane play an important role in determining the polarization selectivity and properties of excitonic transitions. We identified four distinct band-edge transitions at 3.449, 3.420, 3.386, and 3.326eV. They were identified as E2 and E1 free excitons, E1 excitons bound to a donor, and free-electron-to-bound-hole transition, respectively. Unlike previously reported results on relatively thick nonpolar films, the E1 exciton (lowest energy) was mainly polarized to E⊥c and weakly polarized to E∥c under strong biaxial compressive strain in the 100nm thick film. The E2 exciton (next higher energy) was exclusively polarized to E∥c. The localization energy of DX is 34meV, which is much larger than that in polar ZnO, and the DX was not thermally delocalized even at room temperature.
28 November 2016 in Physical Chemistry Chemical Physics
We fabricated Cu(In,Ga)Se2 (CIGS) solar cells with chemical-bath deposited (CBD) ZnS buffer layers with different deposition times. The conversion efficiency and the fill factor of the CIGS solar cells reveal a strong dependence on the deposition time of CBD-ZnS films. In order to understand the detailed relationship between the heterojunction structure and the electronic properties of CIGS solar cells with different deposition times of CBD-ZnS films, capacitance–voltage (C–V) profiling measurements with additional laser illumination were performed. The light-soaking effects on CIGS solar cells with a CBD-ZnS buffer layer were investigated in detail using current density–voltage (J–V) and C–V measurements with several different lasers with different emission wavelengths. After light-soaking, the conversion efficiency changed significantly and the double diode feature in J–V curves disappeared. We explain that the major reason for the improvement of efficiency by light-soaking is due to the fact that negatively charged and highly defective vacancies in the CIGS absorber near the interface of CBD-ZnS/CIGS were formed and became neutral due to carriers generated by ultra-violet absorption in the buffer layer.
Raman and emission properties of a nonpolar a-plane InGaN/GaN blue-green light emitting diode (LED) on an r-sapphire substrate are investigated and compared with a conventional c-plane blue-green LED. The output power of the a-plane LED was 1.4 mW at 20 mA. The c-plane LED has higher EQE, but it reaches the maximum at a lower forward current and the droop is faster than the a-plane counterpart. As the reverse bias increased, a blueshift in the PL spectra was not observed in the a-plane structure, which is indicative of an absence of quantum confined Stark effects. However, a strong blueshift in the electroluminescence spectra was still present, which means the In localization effects are relevant in nonpolar InGaN/GaN quantum wells. In the Raman spectra, a strong anisotropy of E2(high) phonon modes was observed. By comparing the frequency of the E2(high) modes, we demonstrate that the residual compressive strain in an a-plane LED is significantly smaller than in the polar counterpart.