Sub-optimal temperature extensively suppresses crop growth during cool-season greenhouse production. Root-zone (RZ) warming is considered an economical option to alleviate crop growth reduction. In this study we cultivated cucumber seedlings in nutrient solution under different air-RZ temperature treatments to investigate the effects of RZ warming on seedling growth- and photosynthesis-related parameters in leaves. The air-RZ temperature treatments included sub-optimal RZ temperature 13°C and sub-optimal air temperature 20/12°C (day/night) (S13), RZ warming at 19°C and sub-optimal air temperature (S19), and RZ warming at 19°C and optimal air temperature 26/18°C (day/night) (O19). In addition, for each air-RZ temperature treatment, half of the seedlings were also treated with 2% (m/m) polyethylene glycol (PEG) dissolved in nutrient solution to distinguish the effect of root-sourced water supply from RZ temperature. At the whole-plant level, S19 significantly increased the relative growth rate (RGR) by approximately 18% compared with S13, although the increase was less than in O19 (50%) due to delayed leaf emergence. S19 alleviated both diffusive and metabolic limitation of photosynthesis in mature leaves compared with S13, resulting in a photosynthetic rate similar to that in O19 leaves. In newly unfolded leaves, S19 significantly promoted leaf area expansion and alleviated stomatal limitation of photosynthesis compared with S13. PEG addition had a limited influence on RGR and leaf photosynthesis, but significantly suppressed new leaf expansion. Thus, our results indicate that under sub-optimal temperature conditions, RZ warming promotes cucumber seedling growth by differently benefiting mature and newly unfolded leaves. In addition, RZ warming enhanced root-sourced water supply, mainly promoting new leaf expansion, rather than photosynthesis.

We aimed to develop an effective bacterial combination that can combat F. oxysporum infection in watermelon using in vitro and pot experiments. In total, 53 strains of Bacillus and 4 strains of Pseudomonas were screened. Pseudomonas strains P3 and P4 and Bacillus strains XY-2-3, XY-13, and GJ-1-15 exhibited good antagonistic effects against F. oxysporum. P3 and P4 were identified as P. chlororaphis and P. fluorescens, respectively. XY-2-3 and GJ-1-15 were identified as B. velezensis, and XY-13 was identified as B. amyloliquefaciens. The three Bacillus strains were anti-fungal, promoted the growth of watermelon seedlings and had genes to synthesize antagonistic metabolites such as bacilysin, surfactin, yndj, fengycin, iturin, and bacillomycin D. Combinations of Bacillus and Pseudomonas strains, namely, XY-2-3+P4, GJ-1-15+P4, XY-13+P3, and XY-13+P4, exhibited a good compatibility. These four combinations exhibited antagonistic effects against 11 pathogenic fungi, including various strains of F. oxysporum, F. solani, and Rhizoctonia. Inoculation of these bacterial combinations significantly reduced the incidence of Fusarium wilt in watermelon, promoted plant growth, and improved soil nutrient availability. XY-13+P4 was the most effective combination against Fusarium wilt in watermelon with the inhibition rate of 78.17%. The number of leaves; aboveground fresh and dry weights; chlorophyll, soil total nitrogen, and soil available phosphorus content increased by 26.8%, 72.12%, 60.47%, 16.97%, 20.16%, and 16.50%, respectively, after XY-13+P4 inoculation compared with the uninoculated control. Moreover, total root length, root surface area, and root volume of watermelon seedlings were the highest after XY-13+P3 inoculation, exhibiting increases by 265.83%, 316.79%, and 390.99%, respectively, compared with the uninoculated control. XY-13+P4 was the best bacterial combination for controlling Fusarium wilt in watermelon, promoting the growth of watermelon seedlings, and improving soil nutrient availability.

Soil salinization severely constrains crop productivity worldwide. In cucumber (Cucumis sativus L.), salt stress induces oxidative damage and impairs photosynthesis. Melatonin (MT) improves abiotic stress tolerance across diverse crops; yet its salt tolerance mechanism in cucumber remains unclear. Under 100 mM NaCl, foliar application of 100 µM MT increased plant height, leaf area, and biomass. Physiologically, MT enhanced antioxidant enzyme activities, increased ascorbate (ASA) and osmolyte levels, and lowered the Na⁺/K⁺ ratio. MT also elevated chlorophyll content (SPAD), indicating protection of the photosynthetic apparatus. Transcriptomics identified 1,355 melatonin-responsive DEGs, with GO/KEGG enrichment in photosynthesis, photosynthesisantenna proteins, and porphyrin–chlorophyll metabolism. WGCNA revealed a brown module strongly associated with MT and enriched in light-harvesting complex (LHC) genes; LHC genes of PSI and PSII were upregulated by MT. Consistently, MT improved photosynthetic rate and reduced H₂O₂ and O₂·⁻ accumulation. Melatonin enhances cucumber salt tolerance by stabilizing photosynthesis—via LHC gene regulation—and mitigating ROS stress, providing a mechanistic basis for improving stress resilience in horticultural crops.

Traditional low-density polyethylene (LDPE) film causes environmental pollution; there is a pressing need to make new bio-based polymers for alternative products, to meet agricultural production needs and for sustainable ecological development. In this study, urea-formaldehyde resin (UF) was modified with polyvinyl alcohol (PVA) and 1–2.5% bio-based sulfonate (BBS). The influence of BBS inducing on the functional groups, microstructure, and thermal behavior was evaluated by Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), differential scanning calorimetry (DSC), and thermogravimetric analysis (TGA). A biodegradable film was prepared with modified UF resin as adhesive and pulp lignocellulose as raw material. The biodegradable mulch film samples were tested for biodegradability, water retention, and cooling soil temperature characters using LDPE and no mulching (NM) as a control. The results showed that with the increase of BBS content, the viscosity and reactivity of modified PUF resin increased, and the free formaldehyde content decreased. A 2%BBS modified PUF resin (2.0BBS/PUF) accelerated the curing process of the PUF resin, formed a flexible macromolecular network structure, and enhanced the toughness of the resin. The biodegradable mulch prepared with PUF, BBS, and 2.0BBS/PUF as adhesives had good water retention. BBS modification increased the degradation rate of mulch by 17.53% compared to the PUF. Three biodegradable films compared with LDPE and NM significantly reduced the soil temperature under summer cucumber cultivation, and the 2.0BBS/PUF coating had the lowest diurnal temperature difference, which provided a suitable soil environment for crop growth.

The gasification filter cake (GFC) has great application potential for improving the characteristics of seedling substrates due to its nutrient richness and excellent water retention capacity. However, GFCs leach heavy metals easily and thus pose certain ecological risks. Sodium silicate can enhance plant resistance to heavy metal toxicity by fixing heavy metals. This study investigated the impact of sodium silicate on cucumber plant growth, the chemical characterization of the substrate, and the distribution and transfer of heavy metals. Sodium silicate was added to the seedling substrate mix at mass rates of 0 g/kg⁻¹ (GFC0), 2 g/kg⁻¹ (GFC2), 4 g/kg⁻¹ (GFC4), and 8 g/kg⁻¹ (GFC8). The seedling substrate was composed of a commercial matrix, caragana compost, and GFC (m:m 7:7:2). The GFC increased the content of total phosphorus (P), available phosphorus (P), and available potassium (K) in the substrate by 31.58%, 16.58%, and 80.10%, respectively. Conversely, the GFC decreased the plant height by 12.3%. Adding sodium silicate to the GFC increased the chlorophyll content of the plants, fixed heavy metals in the substrate, and promoted nutrient absorption and utilization by the plants. Compared with GFC0 without sodium silicate, adding sodium silicate at a mass rate of 2 g/kg⁻¹ (GFC2) reduced the chromium, lead, and cadmium contents by 51.13%, 26.37%, and 90.04%, respectively, which effectively alleviated heavy metal stress and was more conducive to plant growth.