Maleic anhydride was reacted with p-aminophenol and p-toluidine in the presence ofdi-phosphorus pentoxide (P2O5) as a catalyst to produce two compounds: N-(4-hydroxy-phenyl)maleimide (I) and N-(4-methylphenyl)maleimide (II). The new azo compounds I(a-c) and II(a-c) were prepared by the reaction of I and II with three different aromatic amines, namely aniline, p-aminophenol and p-toluidine. The structures of these compounds were confirmed by CHN, FT-IR, 1H-NMR, 13C-NMR, mass spectrum and UV/Vis spectroscopy.
Two new mesogenic monomers, namely 3,3’-dimethoxy-4,4’-di(hydroxyhexoxy)-N-benzylidene-o-Tolidine (Ia) and 4,4’-di(6-hydroxyhexoxy)-N-benzylidene-o-Tolidine (IIa), were reacted with cadmium sulfide (CdS) via an in situ chemical precipitation method in ethanol to produce CdS nanocomposites. A series of different mass compositions of CdS with Ia and IIa ranging from 0.1:1.0 to 1.0:1.0 (w/w) were prepared and characterized using X-ray Diffraction (XRD), Raman spectroscopy, Fourier Transform Infrared Spectroscopy (FT-IR), Transmission Electron Microscopy (TEM), Polarizing Optical Microscopy (POM) and Differential Scanning Calorimetry (DSC), X-ray Photoelectron Spectroscopy (XPS) and Photoluminescence Spectroscopy (PL). XRD showed that the broad peaks are ascribed to the formation of cubic CdS nanoparticles in both Ia and IIa. The average particle size for both nanocomposites was less than 5 nm with a narrower size distribution when compared with pure CdS nanoparticles. The analyses from POM and DSC demonstrated that mass composition from 0.1:1.0 up to 0.5:1.0 of CdS:Ia nanocomposites showed their enantiotropic nematic phase. On the other hand, polarizing optical microscopy (POM) for IIa nanocomposites showed that the liquid crystal property vanished completely when the mass composition was at 0.2:1.0. PL emissions for CdS: Ia or IIa nanocomposites indicated deep trap defects occurred in these both samples. The PL results revealed that addition of CdS to Ia monomers suppressed the photoluminescence intensity of Ia. However, the introduction of CdS to IIa monomers increased the photoluminescence and was at a maximum when the mass composition was 0.3:1.0, then decreased in intensity as more CdS was added. The XPS results also showed that the stoichiometric ratios of S/Cd were close to 1.0:1.0 for both types of nanocomposites for a mass composition of 1.0:1.0 (CdS:matrix).
30 January 2006 in Journal of Applied Polymer Science
Epoxy resin was prepared by reaction of bisphenol-A and epichlorohydrin. The alkyd resin was prepared by reaction of palm oil as mono fatty acid, glycerol, and phthalic anhydride. The two resins were mixed in ratios of epoxy/alkyd of 50:50, 60:40, 70:30, and 80:20 and showed excellent dispersion. The physical and mechanical properties were determined using scanning electron microscopy (SEM) and FT-IR, viscosity, water resistance, chemical resistance, hardness, impact strength, and adhesion. Thermal properties were analyzed by thermogravimetric analysis. The coating prepared using 80:20 epoxy to alkyd resin exhibited higher hardness but lower impact strength than coatings with lower ratios.
20 August 2009 in Journal of Polymers and the Environment