The flavonoids in Cornus officinalis (CO) have various pharmacological activities, however, the flavonoid instability limits its application in food and pharmaceutical industries. In this study, Cornus officinalis flavonoid (COF) microcapsules were prepared by using a combination of whey isolate protein (WPI), soy isolate protein (SPI), gelatin (GE), and maltodextrin (MD) as wall materials, respectively. Meanwhile, the encapsulation efficiency, solubility, color, particle size, thermal stability and microstructure as well as the antioxidant capacity of microcapsules were assessed. When the protein/MD ratio was 3:7, three kinds of combined wall materials realized high encapsulation efficiency (96.32–98.24%) and water solubility index (89.20–90.10%). Compared with other wall material combinations, the microcapsules with WPI-MD wall ratio at 3:7 had lower particle size (7.17 μm), lower moisture content (6.13%), higher encapsulation efficiency (98.24%), better water solubility index (90.1%), higher thermal stability (86.00°C), brightness L^* (67.84) and higher 1,1-diphenyl-2-picrylhydrazyl (DPPH) scavenging capacity (6.98 mgVc/g), and better flowability. Results suggested that WPI and MD could be better wall materials applied in encapsulating COF.

The objective of this study is to investigate the effects of pretreatments on the quality of vacuum-fried shiitake mushroom slices. Four different pretreatments addressed in this study were (1) blanching as control, (2) blanching and osmotic dehydration with maltodextrin (MD) solution, (3) blanching, osmotic dehydration, and coating with sodium carboxymethyl cellulose (CMC), (4) blanching and osmotic dehydration, followed by freezing. All samples were pretreated and then fried in palm oil at 90°C with vacuum degree of −0.095 MPa for 30 min. The results showed that pretreatments significantly (p<0.05) affected the moisture content, oil content, color, water activity (aw), total phenolic content, and sensory evaluation of shiitake mushroom chips. The blanching, osmotic dehydration, and coating pretreatment could improve color and sensory evaluation and also minimize the oil uptake of fried chips, whereas this treatment caused the highest reduction of total phenolic contents. There were no significant (p>0.05) differences of fried chip in the texture among the four different pretreatments. The aw values of all the fried chips were less than 0.38, indicating that the products had a long shelf life. Therefore, the blanching, osmotic dehydration, and coating pretreatment before vacuum frying was the most suitable pretreatment for vacuum-fried shiitake mushroom chips.

In order to develop a reliable and rapid method for meat freshness detection, nanocellulose (TOCNF) prepared via the TEMPO (2,2,6,6-tetramethylpiperidine oxidation) oxidation method was used as raw material to prepare hydrogels using Zn²⁺ coordination and binding. Physicochemical properties such as water absorption and porosity were analyzed. It was further used to select suitable hydrogels for the preparation of indication labels after anthocyanin adsorption, and it was applied in the freshness detection of fresh minced pork. Five percent TOCNF (w/w) aqueous solution was homogenized by high shear for 4 min, and 20% (w/w) zinc chloride solution was added to it, so that the concentration of zinc ions could reach 0.25 mol/L. After standing for 24 h, the hydrogel was obtained with good water absorption and a porous three-dimensional network structure. The activation energies of volatile base nitrogen (TVBN) and anthocyanin indicating label color changes were 59.231 kJ/mol and 69.453 kJ/mol, respectively. The difference between the two is within 25 kJ/mol, so the prepared indicator label can accurately visualize the shelf life of fresh pork.

Microwave freeze-drying (MFD) is a new freeze-drying technique, which differs from single microwave treatment; it involves simultaneous effects of microwave power, time, and the moisture state applied to the materials. In this study, the effects of MFD under various microwave power densities (0.5, 1.0, and 1.5 W/g) on the drying characteristics of Chinese yam slices and the physicochemical, pasting, and thermal properties as well as the starch digestibility of the flour were investigated using conventional hot air drying (HAD) at 50 °C as a control. Compared to HAD, MFD shortened the drying time up to 14.29~35.71%, with a higher drying efficiency at a high microwave power density (1.5 W/g). MFD yam flours provided benefits over HAD products in terms of color, water/oil absorption capacity, and solubility, exhibiting high hot-paste viscosity but low resistant starch content. The content of total starch and free glucose of the yam flour and its iodine blue value were significantly influenced by the drying method and the MFD process parameters (p < 0.05). MFD processing could disrupt the short-range ordered structure of yam starch. Among the MFD flours, samples dried by MFD at 1.5 W/g presented the highest ratio of peak intensity at 1047 and 1022 cm⁻¹ (R_1047/1022) value, gelatinization enthalpy, and resistant starch content. These results gave a theoretical foundation for the novel freeze-drying method that MFD applied to foods with a high starch content, enabling the production of a product with the desired quality.