This study presents the numerical simulation and analysis of the characteristics of the flood inundation in a small-scale coastal urban area due to the intense rainfall and poor inner drainage from the tidal level rise occurring during a typhoon. The employed numerical model is a two-dimensional finite volume model with a well-balanced HLLC (Harten–Lax–Van Leer contact) scheme. The target area is a coastal urban area downstream of the Gohyun river; which is located in Geoje City of Kyungsangnam Province, Korea. This area was significantly damaged by flood inundation due to the heavy rainfall and significant increase in the tidal level during Typhoon “Maemi”, which occurred in September 2003. The numerical model used in this study is verified using the flood inundation traces observed in the selected urban area. Moreover; the characteristics of the flood inundation based on the change in the river inflow due to the increase or decrease in the intensity of the possible heavy rainfall that may occur in the future are simulated and analyzed.
Most studies on the flood flow characteristics at a crossing focus on channels connected orthogonally or at right angle, but studies on non-orthogonally connected channels remain limited. In this study, hydraulic-model experiments and numerical simulations are performed to analyze the characteristics of the water-surface variation in and around a crossing connected non-orthogonally to four flat channels. Comparison of the measured and simulated water depth distributions in and around the crossing indicates that the results are in relatively good agreement. In the experiment where the angle between two upstream channels is 45°, the water flow pattern in and around the crossing corresponds approximately to Type I proposed by Mignot et al. (2008). However, it was found that there is no any flow type to correspond to the water flow pattern measured in the case of the angle of 135°. For analyzing the variation of the water depth in and around the crossing with inflow, numerical simulation is performed by setting the inflow ratio of the two inlet channels to one, three, and six, respectively.
1 February 2015 in Chemical Engineering Research and Design