Operating lignocellulosic fermentation processes to produce fuels and chemicals is challenging due to the inherent complexity and variability of the fermentation media. Real‐time monitoring is necessary to compensate for these challenges, but the traditional process monitoring methods fail to deliver actionable information that can be used to implement advanced control strategies. In this study, a hybrid‐modeling approach is presented to monitor cellulose‐to‐ethanol (EtOH) fermentations in real‐time. The hybrid approach uses a continuous‐discrete extended Kalman filter to reconciliate the predictions of a data‐driven model and a kinetic model and to estimate the concentration of glucose (Glu), xylose (Xyl), and EtOH. The data‐driven model is based on partial least squares (PLS) regression and predicts in real‐time the concentration of Glu, Xyl, and EtOH from spectra collected with attenuated total reflectance mid‐infrared spectroscopy. The estimations made by the hybrid approach, the data‐driven models and the internal model were compared in two validation experiments showing that the hybrid model significantly outperformed the PLS and improved the predictions of the internal model. Furthermore, the hybrid model delivered consistent estimates even when disturbances in the measurements occurred, demonstrating the robustness of the method. The consistency of the proposed hybrid model opens the doors towards the implementation of advanced feedback control schemes.
21 May 2020 in Frontiers in Bioengineering and Biotechnology
Monitoring and control of fermentation processes remain a crucial challenge for both laboratory and industrial-scale experiments. Reliable identification and quantification of the key process parameters in on-line mode allow operation of the fermentation at optimal reactor efficiency, maximizing productivity while minimizing waste. However, state-of-the-art fermentation on-line monitoring is still limited to a number of standard measurements such as pH, temperature and dissolved oxygen, as well as off-gas analysis as an advanced possibility. Despite the availability of commercial biosensor-based platforms that have been established for continuous monitoring of glucose and various biological variables within diabetes healthcare, on-line glucose quantification in fermentation processes has not been implemented yet. For the first time, this work presents a complete study of a commercial flow-through-cell with integrated electrochemical glucose biosensors (1st generation) applied in different media, and importantly, at- and on-line during a yeast fed-batch fermentation process. Remarkably, the glucose biosensor–based platform combined with the developed methodology was able to detect glucose concentrations up to 150 mM in the complex fermentation broth, on both cell-free and cell-containing samples, when not compromised by oxygen limitations. This is four to six-fold higher than previously described in the literature presenting the application of biosensors predominately towards cell-free fermentation samples. The automated biosensor platform allowed reliable glucose quantification in a significantly less resource and time (<5 min) consuming manner compared to conventional HPLC analysis with a refractive index (RI) detector performed as reference measurement. Moreover, the presented biosensor platform demonstrated outstanding mechanical stability in the presence of the fermentation medium. Coupled with the developed methodology it can be readily considered as a simple, robust, accurate and inexpensive tool for real-time glucose monitoring in fermentation processes.
Many anaerobic conversions proceed close to thermodynamic equilibrium and the microbial groups involved need to share their low energy budget to survive at the thermodynamic boundary of life. This study aimed to investigate the kinetic and thermodynamic control mechanisms of the electron transfer during syntrophic butyrate conversion in non-defined methanogenic communities. Despite the rather low energy content of butyrate, results demonstrate unequal energy sharing between the butyrate-utilizing species (17 %), the hydrogenotrophic methanogens (9–10 %), and the acetoclastic methanogens (73–74 %). As a key finding, the energy disproportion resulted in different growth strategies of the syntrophic partners. Compared to the butyrate-utilizing partner, the hydrogenotrophic methanogens compensated their lower biomass yield per mole of electrons transferred with a 2-fold higher biomass-specific electron transfer rate. Apart from these thermodynamic control mechanisms, experiments revealed a ten times lower hydrogen inhibition constant on butyrate conversion than proposed by the Anaerobic Digestion Model No. 1, suggesting a much stronger inhibitory effect of hydrogen on anaerobic butyrate conversion. At hydrogen partial pressures exceeding 40 Pa and at bicarbonate limited conditions, a shift from methanogenesis to reduced product formation was observed which indicates an important role of the hydrogen partial pressure in redirecting electron fluxes towards reduced products such as butanol. The findings of this study demonstrate that a careful consideration of thermodynamics and kinetics is required to advance our current understanding of flux regulation in energy-limited syntrophic ecosystems.
1 January 2014 in International Journal of Systematic and Evolutionary Microbiology
A bacterial consortium that accumulated more than 90 % (w/w) polyhydroxybutyrate (PHB) from lactate was selected in a laboratory-scale bioreactor with a ‘feast–famine’ regime. Bacterial strain YDT, representing a dominant species in this enrichment, was isolated and characterized. Analysis of the 16S rRNA gene sequence revealed that the isolate is a member of the class Gammaproteobacteria , forming an independent phylogenetic lineage. The closest relative of the isolate was Plasticicumulans acidivorans TUD-YJ37T, with 94 % 16S rRNA gene sequence similarity. Strain YDT was an obligate aerobe with large, ovoid, Gram-negative cells, motile by means of a polar flagellum. It utilized a relatively broad spectrum of substrates (e.g. carbohydrates, fatty acids) as carbon and energy sources. The temperature range for growth was 20–45 °C, with an optimum at 40 °C; the pH range was pH 6.0–8.0, with an optimum at pH 7.0. The major respiratory lipoquinones were Q-8 (91 %) and Q-7 (9 %). The polar lipids consisted of diphosphatidylglycerol, phosphatidylglycerol, phosphatidylethanolamine, phosphatidylmonomethylethanolamine and an unidentified aminolipid. The predominant fatty acids in the membrane polar lipids were C16 : 1ω7c, C16 : 0 and C18 : 1ω7c. The G+C content of the genomic DNA was 68.5 mol%. On the basis of the phenotypic, chemotaxonomic and phylogenetic data, the isolate is proposed to represent a novel species in the genus Plasticicumulans , for which the name Plasticicumulans lactativorans sp. nov. is proposed. The type strain is YDT ( = DSM 25287T = NCCB 100398T).