TiO2 has aroused considerable attentions as a promising photocatalytic material for decades due to its superior material properties in several fields such as energy and environment. However, the main dilemmas are its wide bandgap (3–3.2 eV), that restricts the light absorption in limited light wavelength region, and the comparatively high charge carrier recombination rate of TiO2, is a hurdle for efficient photocatalytic CO2 conversion. To tackle these problems, lots of researches have been implemented relating to structural and material modification to improve their material, optical, and electrical properties for more efficient photocatalytic CO2 conversion. Recent studies illustrate that crystal facet engineering could broaden the performance of the photocatalysts. As same as for nanostructures which have advantages such as improved light absorption, high surface area, directional charge transport, and efficient charge separation. Moreover, strategies such as doping, junction formation, and hydrogenation have resulted in a promoted photocatalytic performance. Such strategies can markedly change the electronic structure that lies behind the enhancement of the solar spectrum harnessing. In this review, we summarize the works that have been carried out for the enhancement of photocatalytic CO2 conversion by material and structural modification of TiO2 and TiO2-based photocatalytic system. Moreover, we discuss several strategies for synthesis and design of TiO2 photocatalysts for efficient CO2 conversion by nanostructure, structure design of photocatalysts, and material modification.
Detection and quantification of harmful chemicals and gases is important from the viewpoint of the health and safety of human beings. It has been a challenge to develop materials that can respond to lower concentrations of gases in an extremely short amount of time. Nanomaterials, with their high surface-to-volume ratio, show a superior gas–solid interaction and thereby have the potential to be developed into highly efficient sensing devices. In particular, the development of carbon nanomaterials, such as carbon nanotubes (CNTs), graphene, and related materials, over the past few decades has accelerated the research of chemiresistive gas sensors, in which the gas response is measured on the basis of change in surface resistance as a result of gas interaction. In this chapter, we outline the development of carbon nanostructures-based sensing materials and devices. We briefly discuss the synthesis of nanomaterials followed by gas sensing features and mechanisms. The discussion is broadly divided into two sections: 1D materials, such as CNTs; and 2D materials, such as graphene. The review concludes with an outlook of the future prospects in this area.
We have grown α-Fe2O3 nanorods by solution processing followed by the deposition of Al2O3 overlayer using atomic layer deposition. Al2O3 layer was deposited for two different thicknesses 4 nm and 8 nm and a post-deposition annealing at 550 °C for 2 h in air atmosphere was performed. Crystallinity analysis through x-ray diffraction (XRD) reveals that the α-Fe2O3 nanorods crystallized into rhombohedral structure, whereas the outer Al2O3 layers remained largely amorphous. Interestingly, the interface showed signs of AlFexOy formation as observed through high-resolution transmission electron microscopy images. Gas sensing characteristics were studied using NO2 with 10, 50, and 100 ppm concentrations at operating temperatures of 30 °C, 100 °C, 150 °C and 190 °C. The room temperature sensitivity values obtained in response to 10 ppm NO2 were 31%, which surpassed the previously reported values. A higher concentration of surface adsorbed oxygen on the Al2O3 overlayer, as revealed by the x-ray photoelectron spectroscopy (XPS) analysis, led to enhanced NO2 sensing at room temperature. A lower activation energy (0.29 eV) of barrier to charge transport for Al2O3 coated α-Fe2O3 nanorods compared to that of bare nanorods (0.45 eV), as calculated from the temperature dependent I-V measurements, supported observation of higher sensitivity at room temperature.
1 March 2026 in Journal of Materials Science: Materials in Electronics