Considering requirements such as enhanced unit capacity, the geometric size of wind turbine blades has been increasing; this, in turn, results in a rapid increase in manufacturing costs. To this end, in this paper, we examine the aerodynamics of co-planar multi-rotor wind turbines to achieve higher unit capacity at a lower blade length. The multiple wind rotors are in the same plane with no overlaps. The ALM-LES method is used to investigate the interaction effect of the blade tip vortices, by revealing the regulation of aerodynamic performance and flow field characteristics of the multi-rotor wind turbines. The simulated results suggest an observable reduction in the blade tip vortices generated by blades located closely together, due to the breaking and absorption of the blade tip vortices by the two rotors. This results in increased aerodynamic performance and loads on the multi-rotor wind turbine. The influence between the blade tip vortex is mainly located in the range of 0.2 R from the blade tip, with this range leading to a significant increase in the lift coefficient. Thus, when the wind rotor spacing is 0.2 R, the interaction between the blade tip vortices is low.

Large-scale wind turbines often face the problem of tower clearance safety under extreme gust conditions. Since gust intensity is positively correlated with the change rate of the generator’s speed, a gust identification method is proposed based on wind turbine monitoring data. Furthermore, a novel tower clearance safety protection strategy is proposed, which superimposes some additional speed requirements on the basis of normal pitch rate when identifying extreme gust so as to alleviate the dynamic response of the wind turbine. Simulations and comparison of a 5 MW wind turbine, before and after applying the new strategy, showed that the new strategy can induce an increase in pitch angle for the wind turbine and, simultaneously, avoids the emergency stop caused by the generator’s overspeed. Meanwhile, when the new strategy is adopted, the blade tip’s deformation and the load on the top of the tower are reduced by 19.9% and 52.2%, respectively. Therefore, the proposed strategy can not only protect the safety of the wind turbine but it also reduces costs.