The volatile compounds present in ten edible oils (six refined, two roasted, and two natural pressed) with different fatty acid compositions were measured to study volatile profile and flavor characteristics. The volatile profile of the refined oils was found to be linked to the fatty acid composition. The percentage of alcohol in the volatile profiles, varied from 38.59 to 74.37%, was smaller in refined oils with more linoleic and linolenic acid than those in oils with more oleic acid, while the opposite trend was observed for the percentage of aldehyde, ranging from 20.27 to 37.19%. The total peak area and number of volatile compounds detected in roasted oils were much greater relative to those in natural pressed oils. Ten characteristic compounds were detected exclusively in roasted sesame oil, and seven compounds were found to be unique to roasted perilla oil. 2-Methylpropan-1-ol and hexanal were the only volatile compounds common to all ten oils.
12 April 2018 in European Journal of Lipid Science and Technology
To establish a practical model for evaluating the oxidation of frying oil using aldehydes, the aldehydes of 10 commercial oils during frying at 180 °C were identified using headspace-gas chromatography/mass spectrometry, and the changes of common aldehydes and their correlation with carbonyl values (CV) were analyzed. The results showed that the total peak area of aldehydes increased significantly with heating time, which was related to the fatty acid and tocopherol contents of the oils. There were four common aldehydes with different trends during frying, namely, pentanal, hexanal, (E)-hept-2-enal, and nonanal. Moreover, pentanal with a high correlation with CV was selected as the quality evaluating index of frying oil due to its stable accumulation over time. Based on the linear fitting relationships between CV and pentanal, as well as the initial content ratio of linoleic acid to palmitic acid and total tocopherols in oils, a predictive model was established for evaluating the quality of frying oils with high precision and non-reagent by using mass spectrometry. In summary, this work provides theoretical support for using aldehyde as the quality evaluation index of frying oil and provides a new idea for evaluating oil deterioration from the perspective of volatile compounds.
The decomposition of unsaturated fatty acids and tocopherols in 10 commercial edible oils during deep frying was investigated. The dominant tocopherol in oils rich in polyunsaturated fatty acids (PUFAs) was γ-tocopherol, except for natural perilla oil (δ-tocopherol dominant), and the main tocopherol in oleic acid-rich oils was α-tocopherol. The PUFA-rich oils had higher tocopherol contents than the oleic acid-rich oils. Both the reduction rate of total unsaturated fatty acid (TUFA) and total tocopherol (TToc) were linear with frying time (t). The decomposition rate of TToc is faster than that of TUFA since the slope values obtained from fitting equations (Y = k t) kTToc (1.520–14.483) were obviously larger than for kTUFA (0.155–0.270). By establishing a dynamic decomposition index, unsaturated fatty acids and tocopherol in oils showed dynamic decomposition over multiple frying cycles. The obtained results showed that decomposition characteristics of oils are related to their fatty acid compositions.
Camellia oil with a high oleic acid content is widely used for frying. To comprehensively describe the quality change in camellia oil during frying, the changes in composition, deterioration indicators, and volatile profiles were investigated. The results showed that tocopherols mainly degraded in the early stage of frying, followed by unsaturated fatty acids (UFA). This caused the carbonyl value and total polar compounds level to significantly increase. Moreover, frying promoted the accumulation of volatile compounds in terms of type and abundance, especially aldehydes, which are related to the degradation of UFA. Principal component analysis showed that the frying of camellia oil was divided into three stages. First, the camellia oil with a heating time of 2.5–7.5 h showed excellent quality, where tocopherol played a major role in preventing the loss of UFA and was in the degradation acceleration stage. Subsequently, as tocopherol entered the degradation deceleration stage, the quality of camellia oil heated for 10.0–15.0 h presented a transition from good to deteriorated. Finally, tocopherol entered the degradation stagnation stage, and the quality of camellia oil heated for 17.5–25.0 h gradually deteriorated, accompanied by a high level of volatile compounds and deterioration indicators. Overall, this work comprehensively determined the deterioration of camellia oil during intermittent frying and offered valuable insights for its quality evaluation.