The 6 February 2023 earthquake doublet (Mw 7.7 and Mw 7.6) that occurred on the East Anatolian Fault Zone (EAFZ) triggered a significant amount of soil liquefaction phenomena in SE Türkiye and NW Syria. The great areal extent of the affected area and the necessity of rapid response led to the adoption and improvement of a workflow for mapping liquefaction phenomena based on remote sensing data. Using satellite imagery, we identified 1850 sites with liquefaction manifestation and lateral spreading deformation. We acquired a thorough map of earthquake-triggered liquefaction based on visual mapping with optical satellite imagery (high and very high-resolution) and the aid of radar satellite imagery and interferometry. The majority of sites are found along meandering sections of river valleys, coastal plains, drained lakes, swamps, and lacustrine basins along the East Anatolian Fault, highlighting once again the influence of geomorphology/surficial geology on the distribution of liquefaction phenomena. A total of 95% of the liquefaction occurrences were mapped within 25 km from the surface trace of the fault, confirming the distance from fault rupture as a more effective tool for predicting the distribution of liquefaction than epicentral distance. Thus, taking into consideration the rapid documentation of these phenomena without the limitations in terms of time, cost, and accessibility of the field investigation techniques, this desktop-based approach can result in a rapid and comprehensive map of liquefaction from a strong earthquake, and can also be used as a future guide for subsequent field investigations for liquefaction hazard mapping.
The existence of high potential onshore and offshore active faults capable to trigger large earthquakes in the broader area of Thrace, Greece in correlation with the critical infrastructures constructed on the recent and Holocene sediments of Nestos river delta plain, was the motivation for this research. The goal of this study is twofold; compilation of a new geomorphological map of the study area and the assessment of the liquefaction susceptibility of the surficial geological units. Liquefaction susceptibility at regional scale is assessed by taking into account information dealing with the depositional environment and age of the surficial geological units. In our case, available geological mapping shows a deficient depiction of Pleistocene and Holocene deposits. Taking into consideration the heterogeneously behavior of active floodplains and deltas in terms of liquefaction, a detailed classification of geological units was mandatory. Using data provided by satellite and aerial imagery, and topographic maps, dated before the 1970’s when extensive modifications and land reclamation occurred in the area, we were able to trace fluvial and coastal geomorphological features like abandoned stream/meanders, estuaries, dunes, lagoons and ox-bow lakes. This geomorphological-oriented approach clearly classified the geological units according to their depositional environment and resulted in a more reliable liquefaction susceptibility map of 4 classes of susceptibility; Low, Moderate, High and Very High. The sediments classified as very high liquefaction susceptibility are related to fluvial landforms, the high to moderate liquefaction susceptibility ones in coastal and floodplain landforms, and low susceptibility in zones of marshes. The sediments classified in the highest group of liquefaction susceptibility cover 85.56 km2 of the study area (16.6%). Particular attention was drawn to critical infrastructure (Kavala International Airport “Alexander the Great”) constructed on the most prone to liquefaction areas.
Slope failures along road cuts and highways, occurring due to heavy rainfalls or earthquakes, pose significant threats to people, vehicles, and emergency plans. In the present study, a methodology to assess the stability of rock slopes at a regional scale is proposed using a kinematic analysis and a probabilistic limit equilibrium analysis for plane sliding and wedge failure modes. The workflow adopted is described through its implementation along the main road network of the island of Thasos, located in northern Greece. On-site investigations and measurements along the island’s road network formed the basis of the present study. The results of the kinematic analysis showed that the joint sets, which were identified during the on-site investigations, formed critical intersections that could lead to wedge and plane sliding failures. The on-site measurements and the results of the kinematic analysis were utilized to perform limit equilibrium back-analyses at sites of identified failures due to the water pressure effects to probabilistically estimate the material strength properties of the joints. Subsequently, numerous limit equilibrium analyses were executed within a Monte Carlo simulation framework to produce representative fragility curves of rock slopes against plane sliding and wedge failures along the main road network, due to earthquake loading and water pressures.
Liquefaction is an earthquake secondary effect that can induce failures on both free-field and structural environments. The severity of the phenomena varies from small-scale sand boils to large-scale damages on structures, mainly located on waterfront areas and buildings constructed on areas of high liquefaction potential. In order to estimate this potential, the indices of Liquefaction Potential Index and Liquefaction Severity Number have been proposed and applied to relevant studies. Recently, thousands of new data points derived by in-situ tests conducted on liquefied and non-liquefied sites are available to research. The main goal of this work is to calibrate the severity of liquefaction phenomena as they have been reported after an earthquake with estimated values of LPI and LSN. Our analysis concludes that LPI values seem to better discriminate between liquefaction and non-liquefaction cases, albeit with some overlap. Moreover, the LPI threshold value derived from the compiled dataset utilized in this study as a predictor of liquefaction or not is calculated to be higher than the value proposed in the original published paper introducing the LPI index.
Airport infrastructure plays a crucial role in regional and national economies, as well as during emergencies such as after major earthquakes. However, its functionality remains vulnerable to disruption caused by secondary earthquake effects, such as soil liquefaction. Hence, assess the risk posed to airport facilities by these phenomena becomes paramount for ensuring airport resilience and preparedness in the face of seismic events. This study, introduces a practical and rapid assessment tool for the risk analysis of airport infrastructure located in liquefaction-prone areas. Focusing on the Nestos delta in Greece, where the Kavala International Airport (KVA) is placed, a new methodology is proposed, which combines geological and remote sensing data to assess and map liquefaction susceptibility at local scale. The results reveal that a significant section of KVA’s runway and taxiways are located on highly susceptible soils of abandoned meanders. Using FEMA’s HAZUS methodology the study quantifies the impacts of liquefaction for a given seismic scenario. The analysis estimates a 49% probability of liquefaction for the highly susceptible class, with ground settlements predicted to reach 30cm. The results of the liquefaction hazard analysis are used for the risk assessment of the airport infrastructure, estimating a total direct loss of €22,2 million. The analysis is validated using datasets from three international airports that sustained extensive seismic damage in the past. This research serves toward safeguarding airport infrastructure in liquefaction-prone regions. <!----> <!----> <!----> <!---->