In this study, a novel 2-vinylpyridine functionalized magnetic nanoparticle (Mag-PVP) was successfully prepared. The prepared Mag-PVP was characterized by transmission electronic microscopy (TEM), Fourier transform infrared spectrophotometry (FT-IR), vibrating sample magnetometry (VSM) and thermogravimetric analysis (TGA), and was used for the adsorption of bisphenol A (BPA) from aqueous solutions. Mag-PVP, which is composed of Fe₃O₄ nanoparticles and poly divinylbenzene-2-vinylpyridine (with a thickness of 10 nm), exhibited magnetic properties (M_s = 44.6 emu/g) and thermal stability. The maximum adsorption capacity (Q_m) of Mag-PVP for BPA obtained from the Langmuir isotherm was 115.87 mg/g at 20 °C, which was more than that of Fe₃O₄ nanospheres. In the presence of NaCl, the improved adsorption capacity of Mag-PVP was probably attributed to the screening effect of Mag-PVP surface charge and salting-out effect. In the presence of CaCl₂ and humic acid (HA), the adsorption capacity of BPA decreased due to competitive adsorption. The adsorption of BPA by Mag-PVP increased slightly with the increase in pH from 3.0 to 5.0 and obtained the largest adsorption amount at pH 5.0, which was probably attributed to hydrogen bonding interactions. Moreover, in actual water, Mag-PVP still showed excellent adsorption performance in removing BPA. The high adsorption capacity and excellent reusability performance in this work indicated that Mag-PVP was an effective adsorbent for removing BPA from aqueous solutions.

Ozone is an effective oxidant and disinfectant commonly used for elimination of micropollutants and inactivation of resistant microbes. However, undesirable oxidation/disinfection byproducts such as bromate might form during ozonation. In this study, the UV absorbance and fluorescence indices were applied as surrogate indicators for predicting the inactivation of bacteria and formation of bromate during ozonation of water and wastewater effluents. The inactivation efficiencies of lab-cultured Escherichia coli (E. coli) and autochthonous bacteria were measured by plating (for E. coli only) and flow cytometry with fluorescence staining. During ozonation of E. coli spiked into wastewater effluents (∼106 cell/mL), the priority of inactivation efficiency determined by different cell viability methods were in the order of CFU > membrane damage > DNA damage. Approximately, 99% membrane damage and/or 90% DNA damage are conservatively supposed as an indicator for sufficient bacterial inactivation as well as degradation of antibiotic resistance genes. The related required O3 dosing thresholds for sufficient inactivation of E. coli and autochthonous bacteria refer to ∼0.6 O3/DOC (g/g), ∼50% decrease of UVA254, ∼60% decrease of UVA280, or ∼80% decrease of humic-like fluorescence. Within the range of 106-108 cell/mL, the bacterial concentration did not have significant effects on the required thresholds of the specific O3 doses or spectroscopic indicators required for bacterial inactivation. The addition of 50 mM tert-BuOH as ·OH scavenger increased the required specific ozone doses but decreased the losses of spectroscopic indicators necessary for sufficient bacterial inactivation, and also suggested that the membrane/DNA damages for bacterial inactivation were mainly attributed to the direct O3 attacks. The bromate concentration was determined using ion chromatography with MS/MS detection. The results showed that when O3 was dosed at the required thresholds for sufficient bacterial inactivation, bromate formation could usually be suppressed below 10 μg/L. The present work supports that it is possible to reach a balance between bacterial inactivation and bromate formation.