Multi-speed transmission is the main development direction of hybrid transmission, which has brought higher shift quality requirements than traditional fuel vehicle transmission. However, there is less research on the shifting control of hybrid transmission, especially for the shifting control of dedicated hybrid transmission (DHT), which uses the wet clutch as a shift element. This paper studies the power-on downshift process of a two-speed series-parallel hybrid transmission, proposes a shifting control strategy based on motor active speed regulation, and deeply analyzes the causes of maximum impact during the shifting process. The results show that the reverse torque produced in the process of eliminating the remaining slip is the root cause of the maximum impact. On this basis, two optimization strategies are proposed to reduce the shift impact and improve the shift quality. The simulation results show that the proposed optimization strategies can effectively suppress the shift impact. In the meanwhile, for any control pressure of the OG (off-going) clutch in the speed phase within the range of (2.44–2.53 bar), a high shift quality in which the maximum impact is controlled lower than 10 m/s3 can be achieved, which has high engineering value and practical significance.
As the number of gears in automatic transmissions (AT) increases, the calibration parameters in the gear shift control process of the transmission control unit (TCU) increase exponentially, significantly increasing the calibration workload during engineering development. To address the challenges of high cost and long cycle times associated with traditional manual calibration, this paper proposes an automatic calibration strategy for shift control based on artificial neural networks (ANNs). The core of this method lies in utilizing an ANN to establish a non-linear mapping relationship between shift characteristics and calibration parameters, thereby simulating and replacing the analysis and adjustment process of engineers. In this research, a vehicle simulation model based on a 9-speed automatic transmission (9AT) was first constructed. A large-scale dataset of shift characteristics was obtained by traversing various parameter combinations, and key features were extracted for model training. Simulation results demonstrate that the trained ANN model performs excellently in the automatic calibration process, requiring only 4 to 5 iterations to adjust shift quality to a level comparable to manual calibration. Its convergence speed and efficiency are significantly superior to traditional rule-based calibration methods. Furthermore, the model exhibits a certain degree of generalization ability and robustness across different throttle openings and gear-shifting conditions. The proposed automatic calibration method does not rely on high-precision physical models, effectively shortening the development cycle and improving calibration efficiency, which holds significant application value in the field of automatic transmission engineering development.