Phase-change materials have various applications across industries from thermal energy storage through automotive battery temperature management systems to thermal stabilisation. Many of these applications are shell and tube structures with different shell shapes. However, it is not yet known how the shape of the shell affects the melting, solidification times, and heat transport processes in such structures. To fill this research gap, seventeen shell shapes/orientations were compared using a simulation study. The well-known and validated enthalpy porosity algorithm implemented in the Fluent 2021R2 software was used. The numerical calculations were preceded by the measurement of thermal conductivity, phase change enthalpy, and specific heat during melting and solidification of the phase-change material. The shortest melting time was achieved for a semi-circular shell shape in the downward position, which was 44% shorter than the reference circular case. The shortest solidification times were recorded for an isosceles trapezium in an upward orientation relative to the reference circular case. Therefore, it is possible to significantly reduce the melting time in shell-and-tube systems as a result of the appropriate selection of the shell shape.

The paper is a result of a synergic cooperation of two academic teams, i.e. power engineering and mechanical teams, and a distribution system operator. A real 15 kV overhead line exposed to a catastrophic load of ice and rime was analyzed and three solutions to improve the reliability of the tested object in such conditions were examined. Authors considered: shortening the length of the line spans, heating the main line with increased current and rebuilding the overhead line to a cable line. The researches worked out a FEM model taking into account the newest normatives, simulated the model, experimentally increased the load on the real line with measured wire temperature, and performed multi-variant calculations to determine indicators of reliability, i.e. SAIDI and SAIFI. The analyses were followed by conclusions thanks to which the reliability of power lines exposed to catastrophic icing could be increased. These inferences should be considered and applied by all distribution system operators in Poland.

Thermal energy storage systems utilising phase change materials offer significantly higher energy densities compared to traditional solutions, and are therefore attracting growing interest in both research and application fields. However, the further development of this technology requires effective methods to enhance thermal efficiency. We propose a horizontal periodic shell-and-tube structure as an efficient latent heat thermal energy storage unit. This research aims to analyse heat transfer not only between the tube containing the heat transfer fluid and the phase change material but also between adjacent shell-and-tube units. The results obtained for a single cell within the periodic structure are compared with those of reference single shell-and-tube units with insulated adiabatic and highly conductive shells. The enthalpy–porosity approach, combined with the Boussinesq approximation, is applied to address the heat transfer challenges encountered during melting and solidification. The periodic horizontal shell-and-tube structure proves to be an efficient latent heat thermal energy storage unit with short melting and solidification times. In contrast, the non-periodic case with neglected conduction in the shell increases the melting and solidification times by 213.8% and 21%, respectively. The shortest melting and solidification times were recorded for the case with a periodic horizontal shell-and-tube structure and shell aspect ratios of 0.44 and 1, respectively.