The purpose of this study was to determine the long-term impact of surgical repair and subsequent 6-week immobilization of an Achilles tendon rupture on muscle strength, muscle strength endurance and muscle activity. 63 patients participated in this study on average 10.8±3.4 years after surgically repaired Achilles tendon rupture and short-term immobilization. Clinical function was assessed and muscle strength, strength endurance and muscle activity were measured using a dynamometer and electromyography. Ankle ROM, heel height during heel-raise tests and calf circumference were smaller on the injured than on the contralateral side. Ankle torques during the concentric dorsiflexion tasks at 60°/sec and 180°/sec and ankle torques during the eccentric plantarflexion task and during the concentric plantarflexion task at 60°/sec for the injured leg were significantly lower than those for the contralateral leg. The total work during a plantarflexion exercise at 180°/sec was 14.9% lower in the injured compared to the contralateral leg (p<0.001). Muscle activity for the gastrocnemius muscle during dorsiflexion tasks was significantly higher in the injured than in the contralateral limb. Limited ankle joint ROM and increased muscle activity in the injured leg suggest compensatory mechanisms to account for differences in muscle morphology and physiology caused by the injury.
Purpose: Running shoe cushioning research has focused widely on rearfoot (RF) characteristics, whereas forefoot (FF) characteristics have been rather neglected. However, altered cushioning may affect running biomechanics and respective subjective perception at RF and FF. Thus, this research compared the effect of running shoes with different midsole hardnesses at RF and FF. Methods: Twenty-eight heel-toe runners were tested in five experimental shoe conditions that featured three segmented EVA midsoles (RF, midfoot (MF), FF). Three conditions had the same midsole hardness at RF and FF (soft (SS), medium (MM), hard (HH)). Two conditions had different RF and FF midsole hardness (soft-RF/hard-FF (SH), hard-RF/soft-FF (HS)). All midsoles featured the same MF segment of medium hardness. Vertical ground reaction forces and lower extremity kinematics during stance, subjective cushioning of the heel-toe transition and the overall comfort were quantified. Data were analysed using Kolmogorov-Smirnov tests, repeated measures ANOVA, Bonferroni post-hoc tests (p < 0.05), and effect size analyses (pη2). Results: The consistent midsole shoe conditions showed increased maximum loading rates of impact and propulsion peaks from SS to HH. Respective maximum loading rates of SH were similarly to SS, and respective maximum loading rates for HS were similar to HH. Subjectively, the consistent midsole conditions were rated according to their mechanical properties and softer shoes were preferred over harder shoes. In the varied midsole shoe conditions, SH was perceived similar to SS, whereas HS was perceived similar to MM. Conclusion: The examined biomechanical variables were influenced almost entirely by respective RF cushioning properties. The hard FF did not negatively affect cushioning perception as long as the RF was soft. Combining a soft FF with a hard RF improved inferior cushioning perception associated with shoes being hard at RF and FF.
Retraining walking in patients after hip or knee arthroplasty is an important component of rehabilitation especially in older persons whose social interactions are influenced by their level of mobility. The objective of this study was to test the effect of an intensive inpatient rehabilitation program on walking speed and gait symmetry in patients after hip arthroplasty (THA) using inertial sensor technology. Twenty-nine patients undergoing a 4-week inpatient rehabilitation program following THA and 30 age-matched healthy subjects participated in this study. Walking speed and gait symmetry parameters were measured using inertial sensor device for standardized walking trials (2*20.3 m in a gym) at their self-selected normal and fast walking speeds on postoperative days 15, 21, and 27 in patients and in a single session in control subjects. Walking speed was measured using timing lights. Gait symmetry was determined using autocorrelation calculation of the cranio-caudal (CC) acceleration signals from an inertial sensor placed at the lower spine. Walking speed and gait symmetry improved from postoperative days 15–27 (speed, female: 3.2 and 4.5 m/s; male: 4.2 and 5.2 m/s; autocorrelation, female: 0.77 and 0.81; male: 0.70 and 0.79; P <0.001 for all). After the 4-week rehabilitation program, walking speed and gait symmetry were still lower than those in control subjects (speed, female 4.5 m/s vs. 5.7 m/s; male: 5.2 m/s vs. 5.3 m/s; autocorrelation, female: 0.81 vs. 0.88; male: 0.79 vs. 0.90; P <0.001 for all). While patients with THA improved their walking capacity during a 4-week inpatient rehabilitation program, subsequent intensive gait training is warranted for achieving normal gait symmetry. Inertial sensor technology may be a useful tool for evaluating the rehabilitation process during the post-inpatient period.
1 December 2013 in American Journal of Physical Medicine & Rehabilitation
Objective The aim of this study was to test the hypothesis that hip muscle function (strength and endurance) improves after total hip arthroplasty and is important for minimizing limping gait. Design Fifty-two patients who underwent total hip arthroplasty were assessed before and 6 mos after receiving a unilateral total hip endoprosthesis (Adaptiva stem with a Harris-Galante acetabular component). Severity of limping was assessed using a 4-point ordinal scale. Pain was assessed using a standardized ordinal scale. Eccentric, concentric, and isometric muscle strength and endurance of the hip extensors, flexors, adductors, and abductors were measured using a dynamometer. Results Postoperative limping severity and pain were significantly lower and postoperative muscle strength and endurance were significantly higher than the preoperative values (P < 0.05). The association between impaired muscle strength and endurance and limping severity was stronger postoperatively than preoperatively. This association was stronger for the hip extensor and flexor muscles than for the hip adductor and abductor muscles. Pain level was not associated with postoperative limping severity. Conclusions Hip extensor and flexor muscle strength and endurance seem to be relevant for minimizing postoperative limping in patients after total hip arthroplasty. Rehabilitation programs should include exercises aimed at improving hip extensor and flexor strength and endurance to improve gait function.
Introduction: Basketball contains numerous types of movements and highly specific playing positions, and hence the anthropometric profile of players varies considerably. To date, the subjective demands of basketball footwear have not been investigated in depth, either biomechanically or from the players’ perspective. This study aimed to investigate players’ subjective demands of basketball footwear according to playing position and respective physical game requirements. Methods: A supervised questionnaire survey of 165 basketball players of heterogeneous skill level was carried out. The questionnaire was divided into three sections enquiring about characteristics of (a) subject profile, (b) athletic demands of playing positions, and (c) basketball footwear. The χ2 test and the Kruskal–Wallis test were used for statistical evaluation of the non-parametric data. Results: The three playing positions have very different physical profiles: (1) guards require speed and agility, (2) centres require strength and strong leaping ability, and (3) forward players are versatile all-rounders. Overall, ankle stability was rated the most important shoe characteristic and mid-cut uppers were favoured by the majority of players. Shoe preferences differed only marginally between playing positions: guards put more emphasis on low-weight and more flexible shoes whereas centre players prefer shoes with high stability and injury protection. Accordingly, centre player favoured high-cut uppers. Conclusions: The findings reveal the potential for two position-specific basketball shoe models: (1) a low- to mid-cut agility shoe model for guards and small forwards that has high traction and is supportive during acceleration and cutting movements, and (2) a mid- to high-cut stability shoe for power forwards and centres with the focus on ankle stability and jumping performance. The stability shoe could easily be complemented with additional ankle braces.
This study aims to analyze the influence of relative strength performance, determined by parallel back squats (REL SQ), on 30 m sprinting (LS) and on jumping performance (squat [SJ], countermovement [CMJ]) in a large sample (n = 492) of elite youth soccer players. The soccer players were divided into subgroups based on their strength performance: strength level 1 (0.0–0.5 REL SQ), strength level 2 (>0.5–1.0 REL SQ), strength level 3 (>1.0 to 1.5 REL SQ), strength level 4 (>1.5 to 2.0 REL SQ), and strength level 5 (>2.0 REL SQ). The results of this study show that REL SQ explains 45–53% (r = |0.67–0.73|) of the variance of SJ, CMJ, and LS for the total sample. Strength levels 2–4 showed similar coefficients of correlation in jumping performance (r = |0.42–0.55|) and strength levels 2 and 3 in sprint performance (r = |0.41|). The respective extreme strength levels showed lower coefficients of correlation with the sprinting and jumping performance variables (r = |0.11–0.29|). No coefficients could be calculated for strength level 5 because no athlete achieved an appropriate strength level (>2.0 REL SQ). The data from this study show a clear influence of REL SQ on sprint and jump performance, even in a large sample.