Chongku Yi

Prof. Chongku Yi

School of Civil, Environmental and Architectural Engineering, Korea University, 145 Anam-ro, Seongbuk-gu, Seoul 02841, Korea

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 February 2017 in Materials
Verified
Journal Article
Open access
PDF file
DYDinberu Molla Yemam
Dinberu Molla Yemam
BKBaek-Joong Kim
Baek-Joong Kim
JMJi-Yeon Moon
Ji-Yeon Moon
CYChongku Yi
Chongku Yi
The objective of this study was to investigate the potential use of sand washing waste as filler for epoxy resin mortar. The mechanical properties of four series of mortars containing epoxy binder at 10, 15, 20, and 25 wt. % mixed with sand blended with sand washing waste filler in the range of 0–20 wt. % were examined. The compressive and flexural strength increased with the increase in epoxy and filler content; however, above epoxy 20 wt. %, slight change was seen in strength due to increase in epoxy and filler content. Modulus of elasticity also linearly increased with the increase in filler content, but the use of epoxy content beyond 20 wt. % decreased the modulus of elasticity of the mortar. For epoxy content at 10 wt. %, poor bond strength lower than 0.8 MPa was observed, and adding filler at 20 wt. % adversely affected the bond strength, in contrast to the mortars containing epoxy at 15, 20, 25 wt. %. The results indicate that the sand washing waste can be used as potential filler for epoxy resin mortar to obtain better mechanical properties by adding the optimum level of sand washing waste filler.

4 December 2020 in Applied Sciences
Verified
Journal Article
Open access
PDF file
BGburtuujin gankhuyag
burtuujin gankhuyag
SDSON DASOM
SON DASOM
IJIndong Jang
Indong Jang
CYChongku Yi
Chongku Yi
HLHyerin Lee
Hyerin Lee
Rebar embedded inside reinforced concrete structures becomes corroded due to various factors. However, few studies have focused on the corrosion of pre-rusted rebar embedded in cement composites, and the findings reported thus far are inconsistent. Therefore, in this study, an experimental program was undertaken to examine the effect of pre-rusting on the further corrosion of reinforcements in cement composites. Pre-rust was induced using two different solutions (CaCl2 and HCl). The corrosion rate in the cement composite was analyzed using the half-cell potential and polarization resistance methods. In addition, scanning electron microscopy with energy-dispersive X-ray analysis and X-ray diffraction analysis were used to examine the morphology of the rust. The results show that the corrosion rate of the rebar embedded in the cement composite can be increased by more than 3.8 times depending on the pre-rust conditions (RE: 0.0009 mm/year, HCl: 0.0035 mm/year). In addition, we found that the corrosion products in the pre-rusted layer were comparable to those of the rebar corroded in the marine atmosphere.

15 October 2021 in Materials
Verified
Journal Article
Open access
PDF file
IJIndong Jang
Indong Jang
DSDasom Son
Dasom Son
YSYongjun Son
Yongjun Son
JMJihyeon Min
Jihyeon Min
CYChongku Yi
Chongku Yi
In this study, a new type of bacterial carrier using methylcellulose was presented, and its applicability to self-healing concrete has been explored. Methylcellulose, the main component of a 2 mm pellet-shaped carrier, can remain stable in alkaline environments and expand in neutral or acidic environments. These properties allow bacteria to survive in the high-alkaline and high-pressure environments of early age concrete, and the number of bacteria increases rapidly in the event of cracks, accelerating crack closure. The results show that the survival rate of bacterial spores inside the mortar was increased, and the pellet provides an enhanced biological anchor suitable for bacterial activity, bacterial growth, and mineral precipitation. Further, the results indicate an improved self-healing efficiency compared with mixing bacteria directly into the cement composite.

22 November 2021 in Materials
Verified
Journal Article
Open access
PDF file
CYChongku Yi
Chongku Yi
JLJeeho Lee
Jeeho Lee
KHKee-Jeung Hong
Kee-Jeung Hong
Understanding the bond behavior of steel rebar in concrete is important in order to determine the performance of a reinforced concrete structure. Although numerous studies have been carried out by many researchers to develop a robust model for numerical analysis, no consensus has been reached as the bond behavior depends on hysteresis. In this study, the bond behavior of a steel bar in concrete with pre-existing damage is investigated under low-level cyclic loading. Based on the experimental bond stress and slip curve, a numerical model for finite element analysis to simulate the effect of low-level cyclic loading is proposed. The results from the numerical analysis show good agreement with the experimental data, including accumulated damage on stiffness and strength throughout entire load cycles.

1 September 2019 in Construction and Building Materials
Verified
Journal Article
Closed access
BRB.K. Rajeshwar
B.K. Rajeshwar
IJIndong Jang
Indong Jang
CYChongku Yi
Chongku Yi

30 June 2015 in Journal of the Architectural Institute of Korea Structure & Construction
Verified
Journal Article
Closed access
BKBaek-Joong Kim
Baek-Joong Kim
CPChung-Hoon Park
Chung-Hoon Park
CYChongku Yi
Chongku Yi