In current investigation, effects of incorporation of varying amount of graphite nanoparticles on abrasive wear behavior of AZ31-WC nanocomposites are examined. AZ31-WC-Gr hybrid nanocomposites are developed using ultrasonic vibration associated stir casting technique. Developed hybrid nanocomposites are characterized using optical microscope (OM) and scanning electron microscope (SEM). Compositions of hybrid nanocomposites are investigated by energy dispersive spectroscopy (EDS). Characterization results disclose that reinforcement particles are uniformly distributed in AZ31 matrix. Compositional analysis confirms fortification of reinforcements. Microhardness values of developed hybrid nanocomposites are examined through microhardness tests. Abrasive wear behavior of AZ31 alloy and AZ31-WC-Graphite nanocomposites are investigated for varying sliding distance and varying abrasive grit size in a pin-on-disc tribotester. Abrasive wear tests disclose that incorporation of only 1 wt. % of graphite nanoparticles enhances wear resistance significantly. AZ31-2WC-1Graphite nanocomposite is found to be the most wear resistant material for all experimental conditions. Worn surfaces are scrutinized under SEM and EDS to reveal worn morphology. Investigation of worn surfaces discloses that abrasion and oxidation are main wear mechanism for AZ31-2WC-1Graphite nanocomposite tested at 50 mm track diameter and 800 grit.
The current work investigates the effects of incorporation of Silicon Nitride (Si3N4) nanoparticles in LM6 alloy on the corrosion characteristics and scratch behaviour under ramp loading conditions. Varying amount (0–2 wt%) of Si3N4 nanoparticles are fortified with the aid of ultrasonic treatment assisted stir casting. Basic characterisations are performed on developed materials such as optical microscopy (OM), field effect scanning electron microscopy (FESEM), energy dispersive x-ray analysis (EDAX) and elemental mapping to confirm the incorporation and distribution of nanoparticles in the LM6 matrix. Later, corrosion and scratch tests (under ramp loading) are carried out on the nanocomposite samples for understanding the durability of the developed materials. Corrosion tests are performed through potentiodynamic polarization and electrochemical impedance spectroscopy (EIS) study in 3.5 wt% NaCl solution. Tafel and Nyquist plots reveal that the nanocomposite reinforced with 0.5 wt% Si3N4 nanoparticles exhibited highest corrosion resistance compared to other nanocomposites and base alloy. Results of the scratch tests indicate that the nanocomposites show gradual increase in wear resistance with increase in reinforcement concentration. Also, wear resistance and scratch hardness of the nanocomposites improved by 33% and 54% respectively due to addition of 2 wt% of nano reinforcements over unreinforced base alloy at higher loads. Moreover, friction coefficient is found to be increased as the wt% of nano reinforcements increases and also with applied scratch load from 30 N to 50 N. Finally surfaces of corroded zone and scratch are examined under FESEM and EDAX to observe dominant mechanisms.