This review aims to highlight the current advances in hybrid redox flow battery (HRFB) technology, encompassing one of the best combinations of efficiency, cost and flexibility due to its module construction, which offers independent scaling of power density and energy capacity. This work emphasizes the interest of the scientific community both in (i) studying the properties and principles of HRFB operation in order to improve commonly proposed systems, and in (ii) the development of energy storage devices with new reagent types or RFB concepts. The data provided enhances the reader to conclude whether novel concepts in halogen oxidizers utilization could help to overcome the problem of insufficient power and energy densities of common RFB.
The manuscript deals with the fundamental problem of platinum hydrogen oxidation catalyst poisoning of the hybrid chemical power source based on bromate electroreduction and hydrogen electro-oxidation reactions. The poisoning is caused by the crossover of bromine-containing species through the proton exchange membrane separating compartments of the flow cell. Poisoning results in a drastic decrease in the flow cell performance. This paper describes the results of the direct measurement of bromine-containing species’ crossover through perfluorosulfonic acid membranes of popular vendors in a hydrogen−bromate flow cell and proposes corresponding scenarios for the flow battery charge−discharge operation based on the electrolyte’s control of the pH value. The rate of the crossover of the bromine-containing species through the membrane is found to be inversely proportional to the membrane thickness.
We measured the ring collection coefficient of bromide anion oxidation products in a neutral and slightly alkaline medium on a rotating ring-disk electrode (glassy carbon disk, platinum ring) varying the following parameters: disk electrode rotation velocity, sodium bromide concentration, pH of the medium (in the range of 6–12), anode current on the disk, and the electroreduction potential of the bromide anion oxidation products on the ring. The data obtained are presented via dependences of the cathode ring current on the disk current ratio vs. the ring electrode potential. The analysis of the results was carried out by comparing the experimental polarization curves of the ring electrode with the data of cyclic voltammetry in model solutions to determine the electrical activities of various bromine compounds in positive oxidation states. We claim that the RRDE method could be used to obtain quantitative and qualitative data on the electrooxidation of bromide ions in neutral and alkaline solutions. For the most effective regeneration of the spent oxidizer, the values of pH > 10 and moderate concentrations of NaBr should be used.
Anthraquinone-2,7-disulfonic acid (2,7-AQDS) is a promising organic compound, which is considered as a negolyte for redox flow batteries as well as for other applications. In this work we carried out a well-known reaction of anthraquinone sulfonation to synthesize 2,7-AQDS in mixture with other sulfo-derivatives, namely 2,6-AQDS and 2-AQS. Redox behavior of this mixture was evaluated with cyclic voltammetry and was almost identical to 2,7-AQDS. Mixture was then assessed as a potential negolyte of anthraquinone-bromine redox flow battery. After adjusting membrane-electrode assembly composition (membrane material and flow field)), the cell demonstrated peak power density of 335 mW cm−2 (at SOC 90%) and capacity utilization, capacity retention and energy efficiency of 87.9, 99.6 and 64.2%, respectively. These values are almost identical or even higher than similar values for flow battery with 2,7-AQDS as a negolyte, while the price of mixture is significantly lower. Therefore, this work unveils the promising possibility of using a mixture of crude sulfonated anthraquinone derivatives mixture as an inexpensive negolyte of RFB.
The proposed anthraquinone-bromate cell combines the advantages of anthraquinone-bromine redox flow batteries and novel hybrid hydrogen-bromate flow batteries. The anthraquinone-2,7-disulfonic acid is of interest as a promising organic negolyte due its high solubility, rapid kinetics of electrode reactions and suitable redox potentials combined with a high chemical stability during redox reactions. Lithium or sodium bromates as posolytes provide an anomalously high discharge current density of order ~A cm−2 due to a novel autocatalytic mechanism. Combining these two systems, we developed a single cell of novel anthraquinone-bromate flow battery, which showed a power density of 1.08 W cm−2, energy density of 16.1 W h L−1 and energy efficiency of 72% after 10 charge–discharge cycles.
17 October 2022 in Russian Journal of Electrochemistry
Hydrogen–air fuel cell is one of the promising types of chemical power sources, it has a variety of applications. However, utilization of the cathodic reaction in the fuel cell requires implementation of expensive noble-metal catalysts, which sufficiently increase the fuel cell overall cost. Another approach implies utilization of redox-mediators that can be electrochemically reduced at cathodes under insignificant overpotential without using the catalyst layer, then chemically oxidized by oxygen in the regeneration reactor bulk. In this work, a mixture of phosphomolybdovanadate polyoxometalates is synthesized and prospects of its implementations as a cathode redox-mediator of hydrogen–air fuel cell are assessed. Cyclic voltammograms taken at different pH values and potential scan rates were used for comprehensive study of redox characteristics of the obtained material. The mixture was also tested as a catholyte in the discharge cell of hybrid chemical power source consisting of a combination of H2/O2 gas anode and a liquid cathode of all-vanadium flow-through redox battery. Peak discharge power density of the cell was 30.3 and 34.9 mW/cm2 at 25 and 50°C, respectively. The possibility of the redox-mediator chemical regeneration by oxygen was also evaluated. The peak regeneration current reached 0.7 A. The obtained results demonstrate perspectives of the implementation of synthesized mixture as a hybrid fuel cell redox-mediator.