Maury L. Hull

Prof. Maury L. Hull

orcid

Research Focus & Metrics

Academic Career Length

35Years (1992-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 February 2008 in Journal of Orthopaedic Research
Verified
Journal Article
Open access
PDF file
HCHelena N. Chia
Helena N. Chia
MHMaury L. Hull
Maury L. Hull
The axial and radial compressive moduli of the human meniscus are important material properties in tibiofemoral joint models, but they have not been determined previously for fresh‐frozen tissue. Our goals were to measure the moduli at equilibrium and at a physiological strain rate, to determine whether the axial and radial compressive moduli are equal for each type of loading, and to determine whether they depend on the region (i.e., anterior, middle, posterior) of the meniscus. Samples from each region from 10 fresh‐frozen human medial menisci were tested in unconfined compression at four strain levels (3%, 6%, 9%, and 12%) at 32%/s, a strain rate determined to be physiologically relevant to walking, and then allowed to reach equilibrium in stress relaxation. At equilibrium, the axial and radial compressive moduli at 12% strain were 83.4 kPa and 76.1 kPa, respectively (p = 0.58), whereas at the physiological strain rate, the axial and radial compressive moduli at 12% strain were 718 kPa and 605 kPa, respectively (p = 0.61). At the physiological strain rate, the modulus increased with increasing strain (79.2 kPa at 3% strain vs. 662 kPa at 12% strain) and the modulus in the anterior region (1,048 kPa at 12% strain) was significantly greater than that in the posterior region (329 kPa at 12% strain) (p = 0.04). Our study supports a plane of isotropy for the material properties of meniscal tissue. However, the material behavior is strongly nonlinear because the compressive modulus is several orders of magnitude smaller than previously reported values for tensile modulus. Further, the compressive modulus depends on the activity of interest (i.e., static such as standing or dynamic such as walking) due to viscoelastic effects, the strain level, and the region of the tissue. © 2008 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 26:951–956, 2008

21 October 2015 in Journal of Bone and Joint Surgery
Verified
Journal Article
Closed access
JRJoshua D. Roth
Joshua D. Roth
Stephen HowellStephen Howell
Stephen Howell
MHMaury L. Hull
Maury L. Hull
Verly tight or overly loose soft-tissue restraints after total knee arthroplasty. Accordingly, the purpose of the present study was to determine whether the laxities at 0°, 45°, and 90° of flexion are equal in the native knee. Methods: Seven different laxities were measured at 0°, 45°, and 90° of flexion in ten fresh-frozen native cadaveric knees (with intact menisci, cartilage, and ligaments) by applying loads of ±5 Nm in varus-valgus rotation, ±3 Nm in internal-external rotation, 100 N in distraction, and ±45 N in anterior-posterior translation with use of a six-degrees-of-freedom load application system. Results: The mean laxities (and standard deviations) at 45° of flexion were 1.7° ± 0.6° greater in varus, 0.9° ± 0.4° greater in valgus, 10.2° ± 2.7° greater in internal rotation, 10.1° ± 2.0° greater in external rotation, 1.7 ± 1.0 mm greater in distraction translation, and 3.3 ± 1.5 mm greater in anterior translation than those at 0° of flexion. The mean laxities at 90° of flexion were 2.5° ± 0.8° greater in varus, 1.0° ± 0.5° greater in valgus, 10.0° ± 4.6° greater in internal rotation, 10.1° ± 4.5° greater in external rotation, 1.8 ± 0.7 mm greater in distraction, and 1.6 ± 1.2 mm greater in anterior translation than those at 0° of flexion. The mean anterior translation at 90° of flexion was 1.7 ± 0.9 mm less than that at 45° of flexion. Conclusions: Because five of the seven laxities were at least 1.7° or 1.6 mm greater at both 45° and 90° of flexion than those at 0° of flexion, the laxities of the native knee measured in this study are unequal at these flexion angles and therefore do not support the goal of gap-balancing in total knee arthroplasty. Clinical Relevance: One possible disadvantage of changing the native laxities at 45° and 90° of flexion to match those at 0° of flexion in a total knee arthroplasty is the overly tight soft-tissue restraints relative to those of the native knee, which patients may perceive as pain, stiffness, and/or limited flexion....

18 June 2014 in Journal of Bone and Joint Surgery
Verified
Journal Article
Closed access
YGYu Gu
Yu Gu
JRJoshua D. Roth
Joshua D. Roth
Stephen HowellStephen Howell
Stephen Howell
MHMaury L. Hull
Maury L. Hull
The goal of the present study was to calculate the frequency and range of these undesirable consequences. Methods: Four methods of mechanically aligned total knee arthroplasty were simulated on fifty normal three-dimensional bone models of the lower extremity from white subjects. Each method resected the distal aspect of the femur and proximal aspect of the tibia perpendicular to their respective mechanical axes. Setting the posterior joint line perpendicular to the anteroposterior axis of the trochlear groove (Method 1), parallel to the transepicondylar axis (Method 2), externally rotated 3° with respect to the posterior condylar axis (Method 3), and parallel to the tibial resection in 90° of flexion with the use of gap-balancing (Method 4) aligned internal-external rotation of the femoral component. Results: The proportion of total knee arthroplasties requiring a ≥2-mm release of a tight collateral ligament was 34% for the medial collateral ligament and 30% for the lateral collateral ligament. The proportion of total knee arthroplasties with ≥2 mm of instability between 0° of extension and 90° of flexion was 56% in the medial compartment and 6% in the lateral compartment for Method 1, 74% and 6% for Method 2, and 42% and 0% for Method 3. Method 4 did not cause ligamentous instability. The proportion of arthroplasties with a ≥2° change from normal was 58% for limb alignment and 58% for knee alignment. Conclusions: Surgeons should be aware that, when using the four methods of mechanically aligning a total knee arthroplasty, they will frequently have to manage a wide range of collateral ligament imbalances that are complex, cumulative, and uncorrectable by collateral ligament release, and a wide range of changes in limb and knee alignment from normal. Patients who perceive these changes in stability, limb alignment, and knee alignment may be dissatisfied and require counseling....

1 November 2000 in Journal of Orthopaedic Research
Verified
Journal Article
Closed access
PDF file
KLKate Lechner
Kate Lechner
MHMaury L. Hull
Maury L. Hull
Stephen HowellStephen Howell
Stephen Howell

1 July 2002 in Arthroscopy
Verified
Journal Article
Closed access
PDF file
TDTammy L. Haut Donahue
Tammy L. Haut Donahue
Stephen HowellStephen Howell
Stephen Howell
MHMaury L. Hull
Maury L. Hull
CGColin Gregersen
Colin Gregersen