This study aims at preparing electrospun chitosan/gelatin nanofiber scaffolds reinforced with different amounts of graphene nanosheets to be used as antibacterial and wound-healing scaffolds. Full characterization was carried out for the different fabricated scaffolds before being assessed for their antimicrobial activity against Escherichia coli and Staphylococcus aureus, cytotoxicity, and cell migration capacity. Raman and transmission electron microscopies confirmed the successful reinforcement of nanofibers with graphene nanosheets. Scanning electron microscopy and porosity revealed that nanofibers reinforced with 0.15% graphene nanosheets produced the least diameter (106 ± 30 nm) and the highest porosity (90%), in addition to their good biodegradability and swellability. However, the excessive increase in graphene nanosheet amount produced beaded nanofibers with decreased porosity, swellability, and biodegradability. Interestingly, nanofibers reinforced with 0.15% graphene nanosheets showed E. coli and S. aureus growth inhibition percents of 50 and 80%, respectively. The cell viability assay showed no cytotoxicity on human fibroblasts when cultured with either unreinforced or reinforced nanofibers. The cell migration was higher in the case of reinforced nanofibers when compared to the unreinforced nanofibers after 24 and 48 h, which is substantially associated with the great effect of the graphene nanosheets on the cell migration capability. Unreinforced and reinforced nanofibers showed cell migration results up to 93.69 and 97%, respectively, after 48 h.

A significant number of deaths are reported annually worldwide due to microbial and viral infections. The development of protective medical textiles for patients and healthcare professionals has attracted many researchers’ attention. Therefore, this study aims to develop smart drug-eluting nanofibrous matrices to be used as a basic material for medical textile fabrication. First, chitosan/gelatin nanofibers were selected as the basic material owing to the wide antimicrobial activity of chitosan and the capability of gelatin to be hydrolyzed in the abundance of the papain-like protease (PLpro) enzyme secreted by SARS-CoV-2. Daclatasvir (DAC), an NS5A inhibitor, was selected as the model drug based on in silico studies where it showed high anti-SARS-CoV-2 potential compared to FDA-approved references. Due to their reported antimicrobial and antiviral activities, ZnO NPs were successfully prepared and incorporated with daclatasvir in chitosan/gelatin nanofibrous matrices through electrospinning. Afterward, an in vitro release study in a simulated buffer revealed the controlled release of DAC over 21 days from the nanofibers compared to only 6 h for free DAC. On the other hand, the abundance of PLpro induced the complete release of DAC from the nanofibers in only 4–8 h. Finally, the nanofibers demonstrated a wide antimicrobial activity against S. aureus, E. coli, and C. albicans.

This study aims at preparing propranolol-loaded trehalosomes (a trehalose-coated liposome) to be used as an antiproliferative agent for treating skin cancer. A factorial design was used to select the optimum formula, where trehalose, lecithin, and Tween 80 levels were studied. A total of 24 runs were prepared and characterized according to size, charge, entrapment efficiency, and release after 3 h to select the optimum formula. The optimized formula was investigated using TEM, DSC, and FTIR. Cell studies were carried out against the human melanoma cell line to measure cytotoxicity, apoptosis/necrosis, and cell cycle arrest. In silico studies were conducted to understand the interaction between propranolol and the influential receptors in melanoma. The results showed the selected formula consisted of trehalose (175 mg), lecithin (164 mg), and Tween 80 (200 mg) with a size of 245 nm, a charge of −9 mV, an EE% of 68%, and a Q3 of 62%. Moreover, the selected formula has good cytotoxicity compared to the free drug due to the synergistic effect of the drug and the designed carrier. IC₅₀ of free propranolol and the encapsulation of propranolol were 17.48 μg/mL and 7.26 μg/mL, respectively. Also, propranolol and the encapsulation of propranolol were found to significantly increase early and late apoptosis, in addition to inducing G1 phase cell cycle arrest. An in silico virtual study demonstrated that the highest influential receptors in melanoma were the vitamin D receptor, CRH-R1, VEGFR 1, and c-Kit, which matches the results of experimental apoptotic and cell cycle analysis. In conclusion, the selected formula has good cytotoxicity compared to the free drug due to the synergistic effect of the drug and the designed carrier, which make it a good candidate as an antiproliferative agent for treating skin cancer.

Purpose: This study aims to prepare Loratadine-loaded chitosan/tannic acid nanoparticles (LOR-CS/TAN NPs) through ionic gelation to be used as an anti-proliferative agent to aid in overcoming breast cancer propagation. Methods: First, in-silico virtual screening was carried out to select the most appropriate anti-histaminic drug based on its inhibitory effect on the H1-histamine receptor, resulting in the selection of Loratadine (LOR). Molecular interaction between LOR with chitosan (CS), a positively charged polymer, and hyaluronan, a negatively charged polymer, was investigated separately through molecular docking, leading to the selection of CS. Optimization was carried out using Box Behnken Design, with concentrations of CS, LOR, and tannic acid (TAN) as independent variables. The optimized nanoparticles were then examined through morphological and physicochemical studies. Cell studies against the MCF-7 breast cancer cell line were conducted to assess cytotoxicity, cell cycle, apoptosis, and necrosis. Results: The optimum formulation was determined to be CS (0.2% w/v), LOR (1:2 weight ratio to CS), and TAN (1:30.6 weight ratio to CS). The optimized LOR-CS/TAN NPs exhibited a size of 283 nm, a polydispersity index (PDI) of 0.102, and an entrapment efficiency of 78%, along with sustained drug release for 24 hours. The results demonstrated that LOR-CS/TAN NPs possess higher anti-cancer activity compared to free LOR. This enhanced activity is attributed to the synergistic effect of the drug and the designed nanoparticle, particularly due to the presence of tannic acid. Conclusion: In conclusion, Loratadine-loaded chitosan/tannic acid nanoparticles (LOR-CS/TAN NPs) demonstrated enhanced anti-cancer activity against the MCF-7 breast cancer cell line. The synergistic effect of Loratadine and the nanoparticle system, particularly due to the presence of tannic acid, resulted in higher cytotoxicity compared to free Loratadine. These findings suggest that LOR-CS/TAN NPs have significant potential as a novel anti-proliferative agent for breast cancer therapy.