We propose a dual junction Cu2ZnSnS4/Cu2ZnSnSe4 (kesterite/kesterite) based tandem configuration and analyze its prospect and viability as a solar cell. Cu2ZnSnS4 and Cu2ZnSnSe4, both having the kesterite crystal structure, are used as the main absorbers for the top and bottom of cells, respectively. We optimize the thickness of the absorbers using optoelectronic simulations and investigate the effect of absorber thickness on short circuit current density and open circuit voltage. The optimized thicknesses for peak efficiency are found to be 200 nm and 850 nm for Cu2ZnSnS4 and Cu2ZnSnSe4, respectively. The maximum efficiency of the tandem cell is estimated to be 19.87% including recombination effects such as Shockley–Read–Hall (SRH) and radiative recombination mechanisms. We also investigate the effect of band gap on the performance of the tandem cell and show that a 21.74% efficient tandem cell can be achieved for optimized band gaps. Finally, we report that efficiency could be further enhanced by replacing the CdS buffer layer with eco-friendly ZnS buffer layer and optimizing the tandem structure. The proposition and computational analysis presented in this work may help in achieving higher efficiency kesterite solar cells.
Fiber-based quantum networks require photons at telecommunications wavelengths to interconnect qubits separated by long distances. Trapped ions are leading candidates for quantum networking with high-fidelity two-qubit gates, long coherence times, and the ability to readily emit photons entangled with the ion's internal qubit states. However, trapped ions typically emit photons at wavelengths incompatible with telecommunications fiber. Here, we demonstrate frequency conversion of visible photons, emitted from the S–P dipole transition of a trapped Ba+ ion into the telecommunications C-band. These results are an important step toward enabling a long-distance trapped ion quantum internet.
Trapped ions are promising candidates for nodes of a scalable quantum network due to their long-lived qubit coherence times and high-fidelity single- and two-qubit gates. Future quantum networks based on trapped ions will require a scalable way to route photons between different nodes. Photonic integrated circuits from fabrication foundries provide a compact solution to this problem. However, these circuits typically operate at telecommunication wavelengths that are incompatible with the strong dipole emissions of trapped ions. In this work, we demonstrate the routing of single photons from a trapped ion using a photonic integrated circuit. We employ quantum frequency conversion to match the emission of the ion to the operating wavelength of a foundry-fabricated silicon nitride photonic integrated circuit, achieving a total transmission of 31.0% ± 0.9% through the device. Using programmable phase shifters, we switch the single photons between the output channels of the circuit and demonstrate a 50:50 beam splitting condition. These results constitute an important step towards programmable routing and entanglement distribution in large-scale quantum networks and distributed quantum computers.
Thin-film silicon solar cells have sparked a great deal of research interest because of their low material usage and cost-effective processing. Despite the potential benefits, thin-film silicon solar cells have low power-conversion efficiency, which limits their commercial usage and mass production. To solve this problem, we design an ultrathin dual junction tandem solar cell with Cu2ZnSnS4 (CZTS) and crystalline silicon (c-Si) as the main absorbing layer for the top and bottom cells, respectively, through optoelectronic simulation. To enhance light absorption in thin-film crystalline silicon, we use silver nanoparticles at the rear end of the bottom cell. We utilize amorphous Si with a c-Si heterojunction to boost the carrier collection efficiency. Computational analyses show that within 9 μm thin-film c-Si, we achieve 28.28% power conversion efficiency with a 220 nm top CZTS layer. These findings will help reduce the amount of Si (∼10 vs. ∼180 μm) in silicon-based solar cells while maintaining high power conversion efficiency.