In this study, activated carbon (AC) derived from orange, mandarin, and banana peels has been utilized as an adsorbent for the removal of a cationic dye, methylene blue, from aqueous solutions. The batch adsorption technique was used with these materials under different conditions of contact time, initial dye concentration (10–100 mg/L), solution pH (4–12), and AC dosage (0.05–0.5 g). The characteristics of the prepared ACs were studied via FTIR, mercury porosimetry, and iodine number determination. Banana peels showed the highest removal efficiency compared with the other fruit peels. Adsorption isotherms were modeled with the Langmuir and Freundlich isotherms, and good fitting to the Freundlich isotherm was obtained. The kinetic data were analyzed using pseudo-first-order, second-order, and intraparticles diffusion models, with good fitting to the pseudo-second-order model. The obtained results indicate that AC represents an efficient low-cost adsorbent for the removal of MB from aqueous solutions.
3 June 2011 in Journal of Thermal Analysis and Calorimetry
CKD is a byproduct of the cement industry, and its accumulation in the surrounding represents one of many issues associated with this industry. In this study, CKD was utilized in the fabrication of one-mix geopolymer cement (GP) composite as an economical and environmental solution for disposal of this byproduct. The mechanical properties and durability behavior during various deterioration actions were inspected. The obtained findings demonstrated that, replacing slag by CKD in the fabricated GP could cause an elongation in the setting times and reduction in the compression strength of approximately 50%. However, GPs containing CKD offered an accepted resistance to irradiation by γ-rays and to firing action. Reinforcing the GPs with nano Fe3O4 (NF) or nano TiO2 (NT) accelerated the geopolymerization reaction and offered mechanical properties surprising the control mix, this was related to the micro-filling and catalytic actions of the NPs which supported the formation of symmetrical and organized clusters of CSHs and CASH gel as shown in SEM micrographs. The reinforcing mixes surpassing the control mix in the protection against intrusion of sulfate ions which they could retain about 92% of their strength after 4 months of exposure while the control mix retained 80%. Furthermore, they showed a superior resistance to the destructive effect of irradiation by high dose gamma rays up to 1500 kGy and they retained ~ 75% of their strength after irradiation while the control mix was kept at only 35%. The fabricated composites are recommended for usage in many applied construction fields.
15 January 2020 in Journal of Taibah University for Science
The performance of oil well cement (OWC) incorporating pozzolana under diverse hydrothermal curing circumstances was inspected. OWC was partially replaced by 5 weight% of silica fume (SF) or fly ash (FA). The prepared composites were cured under different hydrothermal circumstances (60°C/0.02 MPa, 100°C/0.1 MPa and 150°C/0.48 MPa) for 7 days. The outcomes established that increasing curing temperature and pressure brought about a decline in the compressive strength magnitudes of various neat OWC pastes. This finding is correlated to the metamorphosis of CSH to the greatly crystalline phase of α-dicalcium silicate hydrate (α-C2SH). Such transformation motivates the destruction of the pore structure and promotes compressive strength decline. Admixing OWC with 5 wt.% SF or FA displayed enrichment in the mechanical aspects accompanied by the progression of highly compact microstructures. Additionally, the presence of SF or FA motivates the advancement of stable and desirable hydration products. DTG/TG, XRD and SEM analyses affirm these results.
28 September 2016 in Journal of Thermal Analysis and Calorimetry