This research aims to provide a comprehensive evaluation of climate change effects on temperature, precipitation and potential evapotranspiration over the country of Iran for the time periods 2010–2039, 2040–2069 and 2070–2099, and under scenarios A2 and B2. After preparation of measured temperature and precipitation data and calculation of potential evapotranspiration for the base time period of 1960–1990 for 46 meteorological stations (with a nationwide distribution), initial zoning of these three parameters over the country was attempted. Maximum and minimum temperatures and values of precipitation were obtained from the HadCM3 model under scenarios A2 and B2 for the three time periods, and these data were downscaled. Corresponding maps were prepared for the three parameters in the three time periods, and spatial and temporal variations of these climatic parameters under scenarios A2 and B2 were extracted and interpreted. Results showed that the highest increase in temperature would occur in western parts of the country, but the highest increase of potential evapotranspiration would occur in the central region of Iran. However, precipitation would vary temporally and spatially in different parts of the country depending on the scenario used and the time period selected.
The accurate forecasts and estimations of the amount of sediment transported by rivers are critical concerns in water resource management and soil and water conservation. The identification of appropriate and applicable models or improvements in existing approaches is needed to accurately estimate the suspended sediment concentration (SSC). In recent decades, the utilization of intelligent models has substantially improved SSC estimation. The identification of beneficial and proper input parameters can greatly improve the performance of these smart models. In this regard, we assessed the C-factor of the revised universal soil loss equation (RUSLE) as a new input along with hydrological variables for modeling SSC. Four data-driven models (feed-forward neural network (FFNN); support vector regression (SVR); adaptive neuro-fuzzy inference system (ANFIS); and radial basis function (RBF)) were applied in the Boostan Dam Watershed, Iran. The cross-correlation function (CCF) and partial autocorrelation function (PAFC) approaches were applied to determine the effective lag times of the flow rate and suspended sediment, respectively. Additionally, several input scenarios were constructed, and finally, the best input combination and model were identified through trial and error and standard statistics (coefficient of determination (R2); root mean square error (RMSE); mean absolute error (MAE); and Nash–Sutcliffe efficiency coefficient (NS)). Our findings revealed that using the C-factor can considerably improve model efficiency. The best input scenario in which the C-factor was combined with hydrological data improved the NS by 16.4%, 21.4%, 0.17.5%, and 23.2% for SVR, ANFIS, FFNN, and RBF models, respectively, compared with the models using only hydrological inputs. Additionally, a comparison among the different models showed that the SVR model had about 4.1%, 13.7%, and 23.3% (based on the NS metric) higher accuracy than ANFIS, FFNN, and RBF for SSC estimation, respectively. Thus, the SVR model using hydrological data along with the C-factor can be a cost-effective and promising tool in SSC prediction at the watershed scale.
Information on the transport of fluvial suspended sediment loads (SSL) is crucial due to its effects on water quality, pollutant transport and transformation, dam operations, and reservoir capacity. As such, adopting a reliable method to accurately estimate SSL is a key topic for watershed managers, hydrologists, river engineers, and hydraulic engineers. One of the most common methods for estimating SSL or suspended sediment concentrations (SSC) is sediment rating curve (SRC), which has several weaknesses. Here, we optimize the SRC equation using two main approaches. Firstly, three well recognized metaheuristic algorithms (genetic algorithm (GA), particle swarm optimization (PSO), and imperialist competitive algorithm (ICA)) were used together with two classical approaches (food and agriculture organization (FAO) and non-parametric smearing estimator (CF2)) to optimize the coefficients of the SRC regression model. The second approach uses separation of data based on season and flow discharge (Qw) characteristics. A support vector regression (SVR) model using only Qw as an input was employed for SSC estimation and the results were compared with the SRC and its optimized versions. Metaheuristic algorithms improved the performance of the SRC model and the PSO model outperformed the other algorithms. These results also indicate that the model performance was directly related to the temporal separation of data. Based on these findings, if data are more homogenous and related to the limited climatic conditions used in the estimation of SSC, the estimations are improved. Moreover, it was observed that optimizing SRC through metaheuristic models was much more effective than separating data in the SCR model. The results also indicated that with the same input data, SVR was superior to the SRC model and its optimized version.