For numerous hydrological applications, information on snow water equivalent (SWE) and snow liquid water content (LWC) are fundamental. In situ data are much needed for the validation of model and remote sensing products; however, they are often scarce, invasive, expensive, or labor‐intense. We developed a novel nondestructive approach based on Global Positioning System (GPS) signals to derive SWE, snow height (HS), and LWC simultaneously using one sensor setup only. We installed two low‐cost GPS sensors at the high‐alpine site Weissfluhjoch (Switzerland) and processed data for three entire winter seasons between October 2015 and July 2018. One antenna was mounted on a pole, being permanently snow‐free; the other one was placed on the ground and hence seasonally covered by snow. While SWE can be derived by exploiting GPS carrier phases for dry‐snow conditions, the GPS signals are increasingly delayed and attenuated under wet snow. Therefore, we combined carrier phase and signal strength information, dielectric models, and simple snow densification approaches to jointly derive SWE, HS, and LWC. The agreement with the validation measurements was very good, even for large values of SWE (>1,000 mm) and HS (> 3 m). Regarding SWE, the agreement (root‐mean‐square error (RMSE); coefficient of determination (R2)) for dry snow (41 mm; 0.99) was very high and slightly better than for wet snow (73 mm; 0.93). Regarding HS, the agreement was even better and almost equally good for dry (0.13 m; 0.98) and wet snow (0.14 m; 0.95). The approach presented is suited to establish sensor networks that may improve the spatial and temporal resolution of snow data in remote areas.
The amount of liquid water in snow characterizes the wetness of a snowpack. Its temporal evolution plays an important role for wet-snow avalanche prediction, as well as the onset of meltwater release and water availability estimations within a river basin. However, it is still a challenge and a not yet satisfyingly solved issue to measure the liquid water content (LWC) in snow with conventional in situ and remote sensing techniques. We propose a new approach based on the attenuation of microwave radiation in the L-band emitted by the satellites of the Global Positioning System (GPS). For this purpose, we performed a continuous low-cost GPS measurement experiment at the Weissfluhjoch test site in Switzerland, during the snow melt period in 2013. As a measure of signal strength, we analyzed the carrier-to-noise power density ratio (C/N0) and developed a procedure to normalize these data. The bulk volumetric LWC was determined based on assumptions for attenuation, reflection and refraction of radiation in wet snow. The onset of melt, as well as daily melt-freeze cycles were clearly detected. The temporal evolution of the LWC was closely related to the meteorological and snow-hydrological data. Due to its non-destructive setup, its cost-efficiency and global availability, this approach has the potential to be implemented in distributed sensor networks for avalanche prediction or basin-wide melt onset measurements.
Water supply of most lowland cultures heavily depends on rain and melt water from the upstream mountains. Especially melt-water release of alpine mountain ranges is usually attributed a pivotal role for the water supply of large downstream regions. Water scarcity is assumed as consequence of glacier shrinkage and possible disappearance due to global climate change (GCC), in particular for large parts of Central and Southeast Asia. In this paper, the application and validation of a coupled modeling approach with regional climate model (RCM) outputs and a process-oriented glacier and hydrological model is presented for the central Himalayan Lhasa River basin despite scarce data availability. Current and possible future contributions of ice melt to runoff along the river network are spatially explicitly shown. Its role among the other water balance components is presented. Although glaciers have retreated and will continue to retreat according to the chosen climate scenarios, water availability is and will be primarily determined by monsoon precipitation and snowmelt. Ice melt from glaciers is and will be a minor runoff component in summer monsoon-dominated Himalayan river basins.
Climate change has a large impact on water resources and thus on hydropower. Hydroelectric power generation is closely linked to the regional hydrological situation of a watershed and reacts sensitively to changes in water quantity and seasonality. The development of hydroelectric power generation in the Upper Danube basin was modelled for two future decades, namely 2021–2030 and 2051–2060, using a special hydropower module coupled with the physically-based hydrological model PROMET. To cover a possible range of uncertainties, 16 climate scenarios were taken as meteorological drivers which were defined from different ensemble outputs of a stochastic climate generator, based on the IPCC-SRES-A1B emission scenario and four regional climate trends. Depending on the trends, the results show a slight to severe decline in hydroelectric power generation. Whilst the mean summer values indicate a decrease, the mean winter values display an increase. To show past and future regional differences within the Upper Danube basin, three hydropower plants at individual locations were selected. Inter-annual differences originate predominately from unequal contributions of the runoff compartments rain, snow- and ice-melt.
7 March 2018 in IEEE Transactions on Geoscience and Remote Sensing
Snow water equivalent (SWE) is a key variable for various hydrological applications. It is defined as the depth of water that would result upon complete melting of a mass of snow. However, until now, continuous measurements of the SWE are either scarce, expensive, labor-intense, or lack temporal or spatial resolution especially in mountainous and remote regions. We derive the SWE for dry-snow conditions using carrier phase measurements from the Global Navigation Satellite System (GNSS) receivers. Two static GNSS receivers are used, whereby one antenna is placed below the snow and the other antenna is placed above the snow. The carrier phase measurements of both receivers are combined in double differences (DDs) to eliminate clock offsets and phase biases and to mitigate atmospheric errors. Each DD carrier phase measurement depends on the relative position between both antennas, an integer ambiguity due to the periodic nature of the carrier phase signal, and the SWE projected into the direction of incidence. The relative positions of the antennas are determined under snow-free conditions with millimeter accuracy using real-time kinematic positioning. Subsequently, the SWE and carrier phase integer ambiguities are jointly estimated with an integer least-squares estimator. We tested our method at an Alpine test site in Switzerland during the dry-snow season 2015-2016. The SWE derived solely by the GNSS shows very high correlation with conventionally measured snow pillow (root mean square error: 11 mm) and manual snow pit data. This method can be applied to dense low-cost GNSS receiver networks to improve the spatial and temporal information on snow.
Soil moisture (SM) is a highly relevant variable for agriculture, the emergence of floods and a key variable in the global energy and water cycle. In the last years, several satellite missions have been launched especially to derive large-scale products of the SM dynamics on the Earth. However, in situ validation data are often scarce. We developed a new method to retrieve SM of bare soil from measurements of low-cost GPS (Global Positioning System) sensors that receive the freely available GPS L1-band signals. The experimental setup of three GPS sensors was installed at a bare soil field at the German Weather Service (DWD) in Munich for almost 1.5 years. Two GPS antennas were installed within the soil column at a depth of 10 cm and one above the soil. SM was successfully retrieved based on GPS signal strength losses through the integral soil volume. The results show high agreement with measured and modelled SM validation data. Due to its non-destructive, cheap and low power setup, GPS sensor networks could also be used for potential applications in remote areas, aiming to serve as satellite validation data and to support the fields of agriculture, water supply, flood forecasting and climate change.