Ahmad O. Hasan

Dr. Ahmad O. Hasan


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 December 2021 in Sustainability
Verified
Journal Article
Open access
PDF file
HAHani Al-Rawashdeh
Hani Al-Rawashdeh
AHAhmad O. Hasan
Ahmad O. Hasan
HAHazem A. Al-Shakhanbeh
Hazem A. Al-Shakhanbeh
Mujahed AldhaifallahMujahed Aldhaifallah
Mujahed Aldhaifallah
Mohamed R. GomaaMohamed R. Gomaa
Mohamed R. Gomaa
Hegazy RezkHegazy Rezk
Hegazy Rezk
During hot days, the temperature inside vehicles parked under the sun is very high; according to previous studies, the vehicle cabin temperature can be more than 20 °C higher than the ambient temperature. Due to the greenhouse effect, the heating that occurs inside a vehicle while it is parked under the sun has an impact on energy crises and environmental pollution. In addition, the increase in the temperature inside the cabin will have an effect on the dashboard and plastic accessories and the leather on the seats will age rapidly. The ventilation of solar energy from the cabin of a vehicle parked under the blazing sun has received a great deal of attention. The present study was conducted to utilize a renewable energy system to operate the ventilation system through a novel portable ventilation system powered by solar energy. Experimental results were obtained for a vehicle with and without the solar ventilation system. The results indicate that the maximum daily average difference in temperature during the experimental tests between the cabin of the car and the atmospheric temperature with and without the solar ventilation system was 7.2 °C and 20.6 °C, respectively. With and without the usage of the system, the minimum average difference in temperature between the automobile’s cabin and the atmospheric temperature was 6.2 °C and 17.6 °C, respectively. The results indicate that the proposed system is effective and that the thermal comfort inside the vehicle’s cabin improved when the vehicle was parked under the hot sun. Therefore, this system helps to protect human bodies, conserve energy, protect the environment, protect the vehicle’s cabin, and provide a comfortable environment.

26 October 2022 in Energies
Verified
Journal Article
Open access
PDF file
HAHani Al-Rawashdeh
Hani Al-Rawashdeh
AHAhmad O. Hasan
Ahmad O. Hasan
Mohamed R. GomaaMohamed R. Gomaa
Mohamed R. Gomaa
AAAhmad Abu-Jrai
Ahmad Abu-Jrai
MSMohammad Shalby
Mohammad Shalby
Quantitative and qualitative analyses of chemical species out of CI engine tailpipe emissions fueled with pure diesel and diesel methanol blends, trapped in dinitro phenylhydrazine (DNPH) solutions, were performed. The formed hydrazine was studied using high-performance liquid chromatography (HPLC) accompanied by a detector for ultraviolet (UV). A set of carbonyl-DNPH derivative standards was developed and compared with engine tailpipe gases produced by both fuel modes. An understanding of carbonyl chemical compounds such as formaldehyde, acetaldehyde, and acrolein (HCHO, CH3CHO, and H2 = CHCHO, respectively) is essential for researchers to know how these chemicals affect human health and the environment. In both fuel modes, acetaldehyde was the main combustible product 25 ppm followed by formaldehyde 17 ppm, croton aldehydes 16 ppm, acrolein 12 ppm, and iso-valerdyhyde 10 ppm. In addition to these species, only a few other chemical species were detected in the exhaust gas. According to this study, carbonyl compounds from blended fuel contribute 15–22% of pure diesel fuel emissions. As shown by the results, engine operating conditions and fuel mode have a strong impact on the total amount of carbonyls released by the engine. Engine performance was highly influenced by different fuel modes and engine speeds. Using pure diesel, the regulated emissions, HC, CO, and NOx, registered high concentrations at a lower speed (1500 rpm) and NOx presented with the highest concentration of 4 g/kWh followed by CO with 1 g/kWh and HC with 0.5 g/kWh.

14 October 2022 in Energies
Verified
Journal Article
Open access
PDF file
AHAhmad O. Hasan
Ahmad O. Hasan
Khamis EssaKhamis Essa
Khamis Essa
Mohamed R. GomaaMohamed R. Gomaa
Mohamed R. Gomaa
The monitoring of environmental contamination is an important issue to protect human health and the atmospheric environment. In this study, the optical imaging of mesh structures not coated and coated with platinum was performed to analyze the optical characteristics of the lattices. A nickel monolith catalyst was manufactured via additive manufacturing and coated with platinum, and it was presented to characterize the catalyst properties. The analysis focused on the process of coating using hydrazine bath as a reducing agent. The results showed an increase in the thickness of the coating with baths with durations of 1.5 h, 2.0 h and 2.5 h. The coating thickness was strongly dependent on time duration. The SEM images and EDX were used to confirm the process of coating and analyze the presence of platinum on the catalyst. Coating layers were very thin, and others were not homogeneous over the surface. When the catalyst was exposed to platinum for 2.5 h, the catalyst showed an efficiency of 0.06% for NOx, 0.10%, for CO and 0.09% for HC reduction.