Platelet-rich fibrin (PRF) membrane is a three-dimensional biodegradable biopolymer, which consists of platelet derived growth factors enhancing cell adhesion and proliferation. It is widely used in soft and hard tissue regeneration, however, there are unresolved problems with its clinical application. Its preparation needs open handling of the membranes, it degrades easily, and it has a low tensile strength which does not hold a suture blocking wider clinical applications of PRF. Our aim was to produce a sterile, suturable, reproducible PRF membrane suitable for surgical intervention. We compared the biological and mechanical properties of PRF membranes created by the classical glass-tube and those that were created in a single-syringe closed system (hypACT Inject), which allowed aseptic preparation. HypACT Inject device produces a PRF membrane with better handling characteristics without compromising biological properties. Freeze-thawing resulted in significantly higher tensile strength and higher cell adhesion at a lower degradation rate of the membranes. Mesenchymal stem cells seeded onto PRF membranes readily proliferated on the surface of fresh, but even better on freeze/thawed or freeze-dried membranes. These data show that PRF membranes can be made sterile, more uniform and significantly stronger which makes it possible to use them as suturable surgical membranes.
Polypropylene (PP) hybrid composites were prepared by the combination of natural reinforcements and poly(ethylene terephthalate) (PET) fibers. Wood, flax, and sugar palm fibers were used to increase stiffness and strength, while PET fibers served to improve impact resistance. Interfacial adhesion was increased by using a maleated PP (MAPP) coupling agent. The hybrid composites containing 20 wt% of the natural fibers were homogenized in a twin‐screw compounder and then injection molded into standard tensile specimens. The amount of PET fibers was changed from 0 to 40 wt% in the composites. Tensile and impact testing, acoustic emission measurements, and scanning electron microscopy (SEM) were used for the characterization of the composites as well as to follow deformation and failure processes. The results proved that the concept of using PET fibers to improve impact resistance works with all natural fibers. Local deformations, the debonding or pullout of the PET fibers, initiate the plastic deformation of the matrix, which consumes considerable energy. The fracture of PET fibers might also contribute to energy absorption. The type of natural fiber does not influence the effect; the amount of PET fibers determines fracture resistance. The improvement of interfacial adhesion by coupling increases strength and slightly improves impact resistance. The overall properties of the hybrid composites prepared are acceptable, sufficiently large stiffness and impact resistance being achieved for a large number of structural applications.