In order to obtain the knowledge about the formation of the oriented structure in the additive manufacturing process, it is required to gain an accurate understanding about the formation and growth of grains. Hence, in this paper, the simulation of laser metal deposition was performed by the volume of fluid technique to predict the primary dendritic arm spacing, fluid flows, and geometry of the deposited layer. Moreover, the laser metal deposition of the Inconel 718 superalloy was performed experimentally to verify the results of simulation. From the results of simulation, a maximum error of about 8% was observed in the prediction of the geometry of the deposited layer. In addition, the difference between the value of primary dendritic arm spacing in the experimental and simulation results was about 14%. The results have also shown that a cellular dendritic structure was formed when the ratio of the temperature gradient to the cooling rate was more than 9 × 108, while when this ratio was less than 9 × 108, a columnar dendritic structure was formed. The results of simulations and experiments showed that an increase in the laser power from 350 to 450 W led to an improvement of about 9.5% in the size of primary dendrite arms due to the reduction in the temperature gradient, while the increase in the scanning speed from 3 to 5 mm/s resulted in a reduction of about 21% in the size of primary dendrite arms due to the faster cooling rate.
23 February 2023 in Journal of Composite Materials
Polymer nanocomposites find diverse applications in the aerospace, automobile and electronic industries due to good corrosion resistance, high specific strength and excellent processing ability. However, the production of complex and larger parts typically requires welding technology. In this research, fused filament fabrication technique was used to prepare polypropylene nanocomposite reinforced with graphene nanoplates. The polypropylene/graphene nanocomposites were then joined using the friction stir welding. Afterward, different analyses such as thermogravimetric analysis, differential scanning calorimetry, scanning electron microscopy, tensile testing and hardness testing were applied to examine the effects of the process parameters on the microstructure and mechanical properties of the nanocomposite. The results of thermal analysis indicated that the addition of graphene nanoplates improved the melting point and crystallinity percentage of the polypropylene nanocomposite. Mechanical characterization of the welded samples indicated that the increase of rotational speed from 500 to 750 rpm enhanced the tensile strength of weld joint, while it reduced the hardness. Moreover, an increase in the welding speed from 10 to 30 mm/min resulted in a reduction in the tensile strength and an improvement in the hardness. The highest tensile strength of the weld was obtained by addition of 1 wt% graphene to polypropylene, whereas the hardness of the weld was maximized by addition of 2 wt% graphene. Nevertheless, the desirable combination of the process parameters for simultaneous enhancement of tensile strength and hardness was achieved by rotational speed of 667 rpm, welding speed of 16 mm/min and graphene content of 1.5 wt%.