Beom-Kyeong Park

Dr. Beom-Kyeong Park

School of Materials Science and Engineering, Pusan National University, Pusan, Korea

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 July 2019 in Energy & Environmental Science
Verified
Journal Article
Closed access
PDF file
BPBeom-Kyeong Park
Beom-Kyeong Park
QZQian Zhang
Qian Zhang
PVPeter W. Voorhees
Peter W. Voorhees
SBScott A. Barnett
Scott A. Barnett
Solid oxide electrolysis cells (SOECs) convert renewable electricity to fuels with efficiency substantially higher than other electrolysis technologies. However, questions remain regarding degradation mechanisms that limit SOEC long-term stability. One of the key degradation mechanisms is oxygen electrode delamination; although prior studies have improved the understanding of this mechanism, it is still difficult to predict how degradation depends on SOEC materials and operating conditions, i.e., temperature, voltage, and current density. Here we present a study aimed at developing a quantitative understanding of oxygen electrode delamination. Experimentally, a life test study of symmetric and full cells with yttria-stabilized zirconia (YSZ) electrolytes and Gd-doped ceria (GDC) barrier layers was done with three different perovskite oxygen electrode materials. Fracture was observed at the perovskite–GDC interface above a critical current density and below a critical operating temperature. A theory is presented that combines a calculation of the effective oxygen pressure across the electrolyte with an estimation of the pressure required for fracture. Fracture is correctly predicted for a critical oxygen partial pressure of ∼7200 atm and an associated electrode overpotential of ∼0.2 V, occurring at the electrode/GDC interface because of the relatively low perovskite fracture toughness. Damage at the GDC/YSZ interface was also observed in some cases and explained by a peak in the oxygen pressure at this interface.

19 May 2020 in Journal of Materials Chemistry A
Verified
Journal Article
Closed access
PDF file
BPBeom-Kyeong Park
Beom-Kyeong Park
SBScott A. Barnett
Scott A. Barnett
The Ni–YSZ-supported SOFC with LSCF–GDC cathode yields the maximum power density of 2.38 W cm −2 at 800 °C via electrolyte thickness reduction and cathode infiltration with PrO x , with a resulting decrease in both the ohmic and polarization resistances.

1 September 2013 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
BPBeom-Kyeong Park
Beom-Kyeong Park
JLJong-Won Lee
Jong-Won Lee
SLSeung-Bok Lee
Seung-Bok Lee
TLTak-Hyoung Lim
Tak-Hyoung Lim
SPSeok-Joo Park
Seok-Joo Park
RSRak-Hyun Song
Rak-Hyun Song

1 February 2020 in Journal of Materials Chemistry A
Verified
Journal Article
Closed access
PDF file
BPBeom-Kyeong Park
Beom-Kyeong Park
RSRoberto Scipioni
Roberto Scipioni
DCDalton Cox
Dalton Cox
SBScott A. Barnett
Scott A. Barnett
This paper addresses the use of Ce0.8Gd0.2O2−δ (GDC) infiltration into the Ni–(Y2O3)0.08(ZrO2)0.92 (YSZ) fuel electrode of solid oxide cells (SOCs) for improving their electrochemical performance in fuel cell and electrolysis operation. Although doped ceria infiltration into Ni–YSZ has recently been shown to improve the electrode performance and stability, the mechanisms defining how GDC impacts electrochemical characteristics are not fully delineated. Furthermore, the electrochemical characteristics have not yet been determined over the full range of conditions normally encountered in fuel cell and electrolysis operation. Here we present a study of both symmetric and full cells aimed at understanding the electrochemical mechanisms of GDC-modified Ni–YSZ over a wide range of fuel compositions and temperatures. Single-step GDC infiltration at an appropriate loading substantially reduced the polarization resistance of Ni–YSZ electrodes in electrolyte-supported cells, as measured using electrochemical impedance spectroscopy (EIS) at various temperatures (600–800 °C) in a range of H2O–H2 mixtures (3–90 vol% H2O). Fuel-electrode-supported cells had significant concentration polarization due to the thick Ni–YSZ supports. A distribution of relaxation times approach is used to develop a physically-based electrochemical model; the results show that GDC reduces the reaction resistance associated with three-phase boundaries, but also appears to improve oxygen transport in the electrode. Increasing the H2O fraction in the H2–H2O fuel mixture reduced both the three-phase boundary resistance and the gas diffusion resistance for Ni–YSZ; with GDC infiltration, the electrode resistance showed less variation with fuel composition. GDC infiltration improved the performance of fuel-electrode-supported full cells, which yielded a maximum power density of 2.28 W cm−2 in fuel cell mode and an electrolysis current density at 1.3 V of 2.22 A cm−2, both at 800 °C.

3 September 2019 in Journal of Materials Chemistry A
Verified
Journal Article
Closed access
PDF file
SZShan-Lin Zhang
Shan-Lin Zhang
DCDalton Cox
Dalton Cox
HYHao Yang
Hao Yang
BPBeom-Kyeong Park
Beom-Kyeong Park
CLChang-Jiu Li
Chang-Jiu Li
SBScott A. Barnett
Scott A. Barnett
Sr(Ti1−xFex)O3−δ (STF) has been explored as a high stable oxygen electrode for oxygen reduction and oxygen evolution reactions.

1 March 2012 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
BPBeom-Kyeong Park
Beom-Kyeong Park
JLJong-Won Lee
Jong-Won Lee
SLSeung-Bok Lee
Seung-Bok Lee
TLTak-Hyoung Lim
Tak-Hyoung Lim
SPSeok-Joo Park
Seok-Joo Park
DSDong-Ryul Shin
Dong-Ryul Shin