Reverse osmosis (RO) is the most popular technology for brackish, seawater and wastewater desalination. An important drawback of RO is membrane fouling, which reduces filtration effectiveness and increase the cost of produced water. This study addresses two important topics of membrane fouling: (i) the impact of different divalent ions on the formation of organic fouling and (ii) online monitoring and prediction of fouling formation. In the absence of divalent ions, dissolved organic matter had little effect on fouling formation, even at 3.5 mgC/L, in the upper range of groundwater concentration. Calcium, strontium and iron enhanced (organic) fouling formation, whereas barium had negligible effect. However, while iron affected fouling throughout the entire tested range (0–0.5 mg/L), calcium and strontium enhanced organic fouling only at high concentrations: more than 140 mg/L and 10 mg/L for calcium and strontium, respectively. An online system was developed for monitoring the formation of organic fouling, consisting of (i) an ex-situ RO cell with a transparent cover, (ii) a video camera continually monitoring the surface of the membrane and (iii) an algorithm which automatically identified changes in the color of the membrane caused by fouling, using a specially designed membrane spacer with colored reference dots. Changes in the color of the membrane surface were normalized to the reference colors, to eliminate all non-fouling related interference. The system was used to record and analyze changes in membrane color during numerous filtration tests. The data was successfully correlated to changes in specific flux (and subsequently to fouling formation rate) and can be applied to monitor and predict the formation of membrane fouling during desalination.
8 July 2022 in Groundwater for Sustainable Development
Groundwater contamination by nitrate and organic chemicals (for example, 1,4-dioxane) is a growing worldwide concern. This work presents a new approach for simultaneously treating nitrate and 1,4-dioxane, which is based on the ultra-violet (UV) sensitization of nitrate and sulfite, and the production of reactive species. Specifically, water contaminated with nitrate and 1,4-dioxane is irradiated by a UV source (5 mg N/L) efficiently degraded 1,4-dioxane, while producing nitrite at levels higher than its maximum contaminant level (MCL) of 1 mg N/L in drinking water. Adding sulfite to the process after 10 min of irradiation reduces the concentration of nitrite without affecting the degradation rate of 1,4-dioxane. The treated water contained elevated levels of sulfate; albeit at much lower concentration than its MCL. Treating water contaminated with nitrate and organic chemicals (often detected concomitantly) typically requires several expensive treatment processes. The proposed approach presents a cost-effective alternative, employing a single system for the treatment of nitrate and organic contaminants.
5 February 2021 in Environmental Science and Pollution Research
This work provides for the first time simple metrics and a decision tree to predict the degradability of contaminants during UV/NO 3− groundwater treatment.
1 January 2020 in Desalination and Water Treatment