Qingjun Du

Dr. Qingjun Du

School of Petroleum Engineering, China University of Petroleum (East China), Qingdao 266580, China

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 October 2016 in Journal of Energy Resources Technology
Verified
Journal Article
Closed access
PDF file
HWHaijun Wu
Haijun Wu
Qingjun DuQingjun Du
Qingjun Du
JHJian Hou
Jian Hou
JLJingsong Li
Jingsong Li
RGRuxiang Gong
Ruxiang Gong
ZLZhitao Li
Zhitao Li

20 October 2020 in Geofluids
Verified
Journal Article
Open access
PDF file
Qingjun DuQingjun Du
Qingjun Du
YLYongge Liu
Yongge Liu
JHJian Hou
Jian Hou
LSLina Shi
Lina Shi
WWWenbin Wang
Wenbin Wang
KZKang Zhou
Kang Zhou
When the depressurization development of a hydrate-bearing layer is initiated, the temperature of the near-wellbore formation quickly decreases to near the equilibrium temperature due to the dissociation of natural gas hydrate Therefore, the secondary generation of natural gas hydrates in the wellbore easily occurs if pressure jumps to a high value due to the changes of production rates or shutdown of the well. Though hydrate generation in the process of high-pressure drilling and gas and water transportation has been widely investigated, the secondary generation of natural gas hydrates caused by pressure jump during the depressurization development process is not fully understood. In this study, the multiphase pipe flow of a horizontal well, the VyniauskasBishnoi generation dynamics of natural gas hydrate, and a decomposition dynamics model developed by Kim and Bishnoi are combined to build a set of horizontal well gasliquidsolid three-phase flow models, which consider the phase transition in the wellbore and distinguished the secondary hydrate generation area in the wellbore under different temperature and pressure conditions. The results show that when the toe-end pressure is 7MPa and the environment temperature is 6.4C, the secondary hydrate generation exists in the horizontal section of the horizontal well, and the maximum hydrate flow velocity in the wellbore is 0.044m3/d. A high toe-end pressure, low environment temperature, and high gas output will result in a greater hydrate generation in the wellbore, and the wellbore pressure will have a remarkable influence on the amount generated and its range.

30 May 2022 in Journal of Energy Resources Technology
Verified
Journal Article
Closed access
PDF file
WZWenlong Zhang
Wenlong Zhang
JHJian Hou
Jian Hou
YLYongge Liu
Yongge Liu
WCWeidong Cao
Weidong Cao
Kang ZhouKang Zhou
Kang Zhou
Qingjun DuQingjun Du
Qingjun Du

25 August 2025 in Processes
Verified
Journal Article
Open access
PDF file
Kang ZhouKang Zhou
Kang Zhou
Qingjun DuQingjun Du
Qingjun Du
With stable global economic development, the energy demand continues to rise, with oil consistently accounting for over 30% of primary energy consumption

15 October 2018
Verified
Conference Paper
Closed access
PDF file
Qingjun DuQingjun Du
Qingjun Du
LSLina Shi
Lina Shi
JHJian Hou
Jian Hou
Yunkai JiYunkai Ji
Yunkai Ji
KZKang Zhou
Kang Zhou
The PDF file of this paper is in Russian. The oil recovery is improved by CO2 huff and puff in the ultra-high watercut reservoir, but gas channeling is very easy to occur. In this paper, the mechanism of increasing driving pressure and inhibiting gas channeling by CO2 foam puff-and-huff in ultra-high watercut reservoir was studied by nuclear magnetic resonance (NMR). The experimental equipment is a visualization experiment system using nuclear magnetic resonance for oil and gas displacement (the magnetic field intensity: 0.3±0.05T). The influence of CO2/water ratio, permeability and displacement velocity on displacement pressure was carried out. The water saturation was determined on the basis of T2 spectrum, and the water distribution image during the experiments were obtained using imaging software. The ratio of displacement pressure difference between the CO2 foam flooding and water flooding at the same injection velocity is defined as resistance factor. The correlation between the resistance factor of CO2 foam and water saturation was established. The experimental results show that with the increase of injected CO2 foam volume, the water saturation decreased gradually, but the resistance factor changed little. After the injection volume reaches 0.5PV, the water saturation is reduced to about 0.62, the resistance factor increases rapidly, thus the water saturation defined as rising pressure water saturation. After the injection volume reaches 5.0PV, the water saturation is reduced to about 0.4, the resistance factor becomes stable. It is shown that the lower the permeability is, the greater the rising pressure water saturation, the smaller the resistance factor. When the CO2/water ratio is low, the foam is at low-quality state, the resistance factor is mainly controlled by the gas flow velocity; when the CO2/water ratio is high, the foam is at high-quality state, the resistance factor is mainly controlled by the water flow velocity; overall, the resistance factor firstly increased and then decreased as the CO2/water ratio increased. The corresponding CO2/water ratio is the optimal value when the resistance factor is maximum. The results helps to further analyze the mechanism of CO2 foam plugging and gas channeling inhibition.

16 July 2021
Verified
Preprint
Open access
YJYunkai Ji
Yunkai Ji
JHJian Hou
Jian Hou
YLYongge Liu
Yongge Liu
Qingjun DuQingjun Du
Qingjun Du
Natural gas hydrates, as an unconventional resource, has been attracting increasing attention. Understanding the characteristics of methane hydrate formation and dissociation in porous media has become important for developing gas hydrates. This work proposes the low-field nuclear magnetic resonance (LF-NMR) technology to investigate the formation and dissociation of methane