Wideband artificial grid dielectric resonator antenna (GDRA) arrays at 32 GHz for mm-wave applications are presented. The antenna array is comprised of a GDRA layer and a substrate integrated waveguide feeding layer. The GDRA array layer is built by embedding small rectangular metal grid structures in low permittivity dielectric polymethyl methacrylate (PMMA) using deep-X-ray lithography (DXRL) and electroforming. The rectangular metallic inclusions significantly increase the effective permittivity of the base material up to 17 by creating high electric flux density regions inside. Low loss SIW feeding with longitudinal slots is utilized to excite the GDRA array layer. A 200.... thin perforated layer of PMMA is applied between the rectangular grid structures and the SIW feedlines to avoid shorting the metal inclusions to the excitation slots, while improving broadband energy coupling to the GDRA layer. The size of the single GDRA array element is only 2.7mm × 2.7mm × 0.5mm (0.29.o λ 0.29.o λ 0.05.o). Four element (1×4) and eight element (1×8) GDRA arrays have been fabricated and measured. A measured impedance bandwidth of 6 GHz with a broadside peak gain of 12 dBi and 76% measured radiation efficiency is obtained at 32 GHz for the 1×8 GDRA array.
A gap with variable geometry is presented for both cantilever beam and fixed-fixed beam actuators as a method to reduce the pull-in voltage while maintaining a required displacement. The method is applicable to beams oriented either in a plane parallel to or perpendicular to a substrate, but is most suitable for vertically oriented (lateral) beams fabricated with a high aspect ratio process where variable gap geometry can be implemented directly in the layout. Finite element simulations are used to determine the pull-in voltages of these modified structures. The simulator is verified against theoretical pull-in voltage equations as well as previously published finite element simulations. By simply varying the gap in a linear fashion the pull-in voltage can be reduced by 37.2% in the cantilever beam case and 29.6% in the fixed-fixed beam case over a structure with a constant gap. This can be reduced a further 4.8% by using a polynomial gap shape (n = 4/3) for the cantilever beam and 1.2% for the fixed-fixed beam by flattening the bottom of the linearly varying gap.