We present the results of the reinforcement of plant root systems in surface soil in a model test to simulate actual precipitation conditions. In the test, Eleusine indica was selected as herbage to reinforce the soil. Based on the various moisture contents of plant roots in a pull‐out test, a fitting formula describing the interfacial friction strength between the roots and soil and soil moisture content was obtained to explain the amount of slippage of the side slope during the process of rainfall. The experimental results showed that the root systems of plants successfully reinforced soil and stabilized the water content in the surface soil of a slope and that the occurrence time of landslides was delayed significantly in the grass‐planting slope model. After the simulated rainfall started, the reinforcement effect of the plant roots changed. As the rainfall increased, the interfacial friction between the roots and the soil exhibited a negative power function relationship with the water content. These conclusions can be used as a reference for the design of plant slope protection and reinforcement.

The utilization of polymers can strengthen soil, but at a high price. In this study, value coefficients were proposed to evaluate the cost-effectiveness of fiber-reinforced roadbeds, and the effects of embankment-slope-influencing factors on the value coefficients were analyzed by response surface methodology. Ultrahigh-molecular-weight polyethylene fiber (UPEF) was used as the reinforcement material for soil. First, the shear strength parameters of fiber soil with different fiber diameters were obtained from the direct shear tests to set the parameters of the finite element models. Second, three factors, namely filling height, slope angle, and fiber diameter, were selected as input parameters based on the Box–Behnken Design (BBD) experimental design method, and their effects on the value coefficient of the fiber soil embankment slope were investigated. Finally, the design parameters at the maximum value coefficient of the fiber soil embankment slope were determined based on the results of the response surface analysis. The results indicated that the addition of UPEF could effectively improve the cohesion of the soil; the interaction between the filling height and fiber diameter is most obvious. The optimization of design parameters based on the value coefficient of the fiber soil slope is a slope-engineering design method considering comprehensive benefits.

Cold-formed steel (CFS) is a typical green building material with the merits of being low-cost, lightweight, high-strength, and recyclable. CFS built-up section beams are widely used in CFS frames owing to their outstanding mechanical properties. However, a simplified and accurate method for calculating the flexural moment capacity of multi-limb built-up beams is missing in specifications. In this study, the flexural behaviors of CFS four-limb built-up beams with closed and open sections are investigated via experiments and finite element (FE) modeling. Firstly, the flexural moment capacities and failure modes of the beams are obtained by four-point bending experiments. The ultimate load capacity of the new open section beam is found to be higher than that of the closed section beam, and the failure mode is local buckling of the web and upper flange. Then, the FE models validated by the tests are developed to conduct an extensive parametric study. Numerical results show that the flexural moment capacity increases with the thickness and web depth. Finally, a simplified calculation method for the flexural moment capacities of the closed and open section beams is proposed by considering the reduction factor of gross section modulus of the built-up section.

The aim of this paper is to study the influence of an effective root system of rhizome plants on the reinforcement of slope soil under freeze-thaw conditions. This study focused on the mechanical properties between roots and clay in the root system of four plant species from different regions of China (northeast, northern, central, and southern areas): Setaria viridis, Eleusine indica, Zoysia japonica, and Carex leucochlora. Based on the interfacial friction effects between the plant roots and the soil, pull-out tests and unconfined compressive strength tests were conducted on the reinforced soil system for varying numbers of freeze-thaw cycles. Several stages of the pull-out process of the root system in clay are explicitly proposed based on the interfacial friction test results. The results showed that the friction effect between Zoysia japonica roots and the soil was the most significant and that these roots had the best reinforcement effect. In contrast, the friction and reinforcement effects between Setaria viridis roots and the soil were the worst, and the resulting unconfined compressive strength was the smallest. However, the freeze-thaw resistance ability of the Setaria viridis and soil system was stronger than that of the Zoysia japonica system.