Locating the edges of magnetized sources provides a fundamental tool in the geologic interpretation of magnetic field data. Much recent effort has been expended on developing improvements to existing edge-detection methods, resulting in purported increases in accuracy and continuity along edges, reduction of noise effects, and limiting the influences of variable depth to source, magnetization direction, and source dip. These endeavors are valuable and provide interpreters with a wider range of tools to carry out geologic interpretations of aeromagnetic data. Nevertheless, survey parameters such as flight height and line spacing impose limits on the quality of edge locations that can be achieved. Using model studies, we quantify the effects that source size, depth, and interference between sources have on calculated edge locations. Based on the known behavior of established edge detectors, we found that many of the newer approaches offer limited advantages over older methods. Consequently, we studied an example of field mapping of geologic contacts in the Canadian Shield, supported by aeromagnetic data, using calculation of a standard edge detector: the horizontal gradient magnitude of the total magnetic field or TF-hgm. Calculated edge locations estimated from this method appear sufficiently accurate and continuous to provide a solid basis on which the mapping campaign was based and executed successfully.
The Patterson Lake corridor (PLC) in the southwestern margin of the Athabasca Basin hosts several high-grade uranium deposits. These deposits are located in the basement up to 900 m below the unconformity surface, raising questions about their affiliation with typical unconformity-related uranium (URU) deposits elsewhere in the basin. Based on cross-cutting relationships four pre- and three syn- to post-mineralization quartz generations were identified. Fluid inclusion analyses indicate that pre-mineralization fluids have salinities ranging from 0.2 to 27.2 wt% NaCl equiv. (avg. 9.0 wt%), whereas syn-mineralization fluids have salinities ranging from 8.8 to 33.8 wt% NaCl + CaCl 2 (avg. 25.4 wt%), with NaCl- and CaCl 2 -rich varieties. The homogenization temperatures ( Th ) of fluid inclusions from pre-mineralization quartz range from 80 to 244°C (avg. 147°C), and from syn-mineralization quartz range from 64 to 248°C (avg. 128°C). Fluid boiling is indicated by the co-development of liquid-dominated and vapour-dominated fluid inclusions within individual fluid inclusion assemblages from the syn-mineralization quartz and is related to episodic fluid pressure drops caused by reactivation of basement faults. Our results indicate that composition and P – T conditions of the ore fluids in the PLC are comparable to those of typical URU deposits in the Athabasca Basin, indicating that the uranium deposits in the PLC formed under similar hydrothermal conditions. Episodic reactivation of basement faults was an important driving force to draw uraniferous fluids from the basin and reducing fluids from the basement to the mineralization sites, forming deep basement-hosted deposits. Supplementary material: Table 1, microthermometric results of type-2 and -5 fluid inclusion assembladges and isolated inclusions from the Patterson Lake corridor, and table 2, microthermometric results of type-6 fluid inclusions from the Patterson Lake corridor are available at https://doi.org/10.6084/m9.figshare.c.5510179 Thematic collection: This article is part of the Uranium Fluid Pathways collection available at: https://www.lyellcollection.org/cc/uranium-fluid-pathways
Basement-hosted uranium deposits of the Patterson Lake corridor are located on the southwestern margin of the Athabasca Basin in atypical hosts: altered and metamorphosed granite, granodiorite, and ultramafic to mafic rocks. Fluid inclusions record incursion of two fluids, NaCl- and CaCl2-dominant, at temperatures up to 250°C and approximately 1 km into the basement during episodic brittle reactivation of high-strain-ductile to brittle-ductile structures, in particular late west- and north-northwest-striking brittle conjugate faults that crosscut the Athabasca sandstone. Isotopic data from pyrite and tourmaline record basinal fluid-rock interactions under fluctuating pressure and oxidizing to reducing conditions. New 3-D geophysical modelling illustrates linkages between the surface architecture and lower crust to mantle and influence of the Clearwater Domain granitic intrusions on the ore systems. High radiogenic heat production from these intrusions and other ca. 1.8 Ga felsic intrusions contributed to a prolonged, elevated geothermal gradient under the Proterozoic basins that permitted shallow (less than 3 km) depths of mineralization.