Over 300 spacecraft weighing less than a kilogram have been launched to date, enabling low-cost satellite or constellation missions. These sub-CubeSat spacecraft have significantly reduced technical requirements and complexity compared to their larger counterparts, such as CubeSats, which are expected to lead to substantial cost benefits and development durations of one year or less. However, the median development time of sub-CubeSat spacecraft so far is more than two years, which can be explained by the lack of an adequate systems engineering framework to aid in managing their unique characteristics. In this article, we present a tailored methodology for sub-CubeSat spacecraft, which aims to reduce their development time and cost, consisting of specific methods, tools, and an Agile development process. This process focuses on Scrum- like short design sprints over the entire satellite system, followed by efficient verification and iteration, in contrast to the typical stage-gate processes of space systems engineering. Two internal space missions as case studies are used to demonstrate that our approach can decrease time-to-orbit and increase confidence in the design, by allowing quick adaptation to imposed constraints, evolving requirements, and unforeseen events.
Moore’s law states that the performance of computers doubles about every two years. This has dramatic consequences for any modern high development and for satellites. The long development cycles cause these expensive assets to be obsolete before the start of their operations. The advancement also presents challenges to their design, particularly from a thermal perspective, as more heat is dissipated and circuits are more fragile. These challenges mandate that faster spacecraft development methods are found and thermal management technologies are developed. We elaborate on existing development methodologies and present our own lean method. We explore the development of a thermal anomaly-detection payload, extending from conception to in-orbit commissioning, to stimulate discussions on space hardware development approaches. The payload consists of four miniaturized infrared cameras, heating sources in view of the cameras simulating an anomaly, an on-board processor, and peripherals for electrical and communication interfaces. The paper outlines our methodology and its application, showcasing the success of our efforts with the first-light activation of our cameras in orbit. We show our lean method, featuring reference technical and management models, from which we derive further development tools; such details are normally not available in the scientific-engineering literature. Additionally, we address the shortcomings identified during our development, such as the failure of an on-board component and propose improvements for future developments.
Space systems miniaturization has been increasingly popular for the past decades, with over 1600 CubeSats and 300 sub-CubeSat sized spacecraft estimated to have been launched since 1998. This trend towards decreasing size enables the execution of unprecedented missions in terms of quantity, cost and development time, allowing for massively distributed satellite networks, and rapid prototyping of space equipment. Pocket-sized spacecraft can be designed in-house in less than a year and can reach weights of less than 10g, reducing the considerable effort typically associated with orbital flight. However, while Systems Engineering methodologies have been proposed for missions down to CubeSat size, there is still a gap regarding design approaches for picosatellites and smaller spacecraft, which can exploit their potential for iterative and accelerated development. In this paper, we propose a Systems Engineering methodology that abstains from the classic waterfall-like approach in favor of agile practices, focusing on available capabilities, delivery of features and design "sprints". Our method, originating from the software engineering disciplines, allows quick adaptation to imposed constraints, changes to requirements and unexpected events (e.g. chip shortages or delays), by making the design flexible to well-defined modifications. Two femtosatellite missions, currently under development and due to be launched in 2023, are used as case studies for our approach, showing how miniature spacecraft can be designed, developed and qualified from scratch in 6 months or less. We claim that the proposed method can simultaneously increase confidence in the design and decrease turnaround time for extremely small satellites, allowing unprecedented missions to take shape without the overhead traditionally associated with sending cutting-edge hardware to space.