The relative casing motion can significantly alter the over-tip-leakage (OTL) flow aerodynamic performances. Traditional tip experimental facilities for relative motion researches, including stationary linear cascade with low-speed moving belt, annular cascade with rotating outer wall, and full-scale experimental rig with rotating blade, were either extremely costly or not capable to reproduce engine-representative casing Mach number. Very recently, a novel design concept for high-speed disk rotor rig has been proposed for tip research. Subsequent to this research, the present study evaluates the aerodynamic performances and the periodicity of the disk rotor rig design using Reynolds-averaged Navier–Stokes computational fluid dynamics simulation. Furthermore, first-of-its-kind experimental results of total pressure loss distributions measured by five-hole probe under high relative casing Mach number are reported. The results demonstrate the applicability of the disk rotor experimental rig for tip aerodynamic investigations.

In high-pressure turbines, there is a large difference in temperature between the mainstream and the turbine blade surface. Most of the turbine blade tip heat transfer studies were conducted under the assumption that the Over-Tip-Leakage (OTL) flow field is independent of the wall thermal condition. Recent numerical and experimental studies have revealed that the two-way coupling effect between aerodynamics and heat transfer should not be neglected. The heat transfer coefficient obtained by the conventional method is not able to match the realistic engine condition accurately. This study investigates the impact of the wall thermal boundary condition on the tip cooling performance of squealer turbine blades. The RANS CFD result was validated against experimental tip heat transfer data obtained from a high-speed test rig with the effect of high-speed relative casing motion. The aerothermal performance for both uncooled and cooled squealer tips was studied at two different gas-to-wall temperature ratios, 1.7 and 1.1; the reference temperature is 204 K. It was found that the location and strength of cavity vortices varied with different wall thermal boundary conditions, leading to different signatures in tip heat transfer and cooling performance. It is recommended that the experimental heat transfer data and film cooling effectiveness obtained at the near-adiabatic wall boundary condition should be corrected before their application to the tip cooling design process. It would be more reliable to match the wall-to-gas temperature ratio during the tip experimental study.

The high-speed Over-Tip-Leakage (OTL) flow has a significant impact on the aerodynamic performance of the High-Pressure Turbine (HPT) passage and generates high thermal load for the blade tip. Different tip sealing and cooling design strategies are applied to reduce the OTL loss and help turbine survive in a high temperature environment. High-speed linear cascade experimental rigs play an important role in understanding the flow physics and evaluating their performance. Multiple blades and passages are often required to maintain a reasonable flow periodicity. To match the engine representative Reynolds number and Mach number, a high-speed multi-passage cascade design inevitably demands more compressed air supply. A very large amount of heating power is also required if the engine condition wall-to-gas temperature ratio needs to be matched. In this study, a simplified 2-Passage linear cascade rig for high-speed tip heat transfer research was developed. Both the design method and the rig performance are presented. Different from existing design method to match two-dimensional blade loading, this study shows there are other design flexibilities, such as assist blade tip gap, tailboard adjustment, and profiling adjustment, to match the periodic three-dimensional OTL flow structures. The design method was validated by experimental effort. High resolution tip heat transfer coefficient distribution at stationary and rotating conditions (Rotating Mach number = 0.35) are reported. The enlarged test model can offer much more improved resolution of optical measurement near the tip region.