Diethyl (carboxymethyl) phosphonate (DECP) was used as the hapten to develop an indirect competitive enzyme-linked immunosorbent assay (IC-ELISA) for detecting organophosphorus pesticides (OPs). Conjugator of DECP with bovin serum albumin (BSA) was used as the immunogen for producing the polyclonal antibodies (PcAbs). Three antisera were obtained after the immune procedure. Characterization studies of the PcAbs indicated that the titer of antiserum-1 was highest in 3 antisera, and antiserum-1 had high affinity and specificity to the parathion, dichlorvos and pirimiphos. The IC-ELISA showed an IC50 of 0.428 micro g/mL with a detection limit of 0.0125 micro g/mL to parathion. The assay also indicated that the IC50 values of pirimiphos and dichlorvos were 0.331 micro g/mL and 1.25 micro g/mL respectively, and the detection limits of pirimiphos and dichlorvos were 0.0116 micro g/mL and 0.048 micro g/mL respectively. Recoveries of parathion, pirimiphos and dichlorvos spiked into water samples ranged from 90% to 160%. The results indicated that the ELISA could be a convenient and supplemental analytical tool for monitoring OPs residues in environmental water samples.
Environmental contamination from pesticide residues is a worldwide public health concern and has attracted increasing attention from researchers over the past several years. In this study, an aptamer-based enzyme-linked immunosorbent assay (apt-ELISA) using enzyme signal amplification has been developed to determine isocarbophos residues. The limit of detection for the apt-ELISA was 0.05 ng/mL for isocarbophos, and the sensitivity was better than that obtained using the traditional ELISA approach. The average recovery of the apt-ELISA ranged from 84 to 97%, and the coefficient of variation ranged from 4.6 to 12.1% when determining the isocarbophos residues in various water samples. The results demonstrate that the proposed approach can be used for routine screening of isocarbophos residues.
A simple and efficient electrochemical sensor based on a homemade reshaped micropipette tip carbon paste electrode is reported. Molecularly imprinted polymer membranes of graphene oxide and polypyrrole are synthesized and modified on the surface of micropipette tip carbon paste electrode. The merit of the method is evaluated under optimized conditions via differential pulse voltammetrics. The prepared sensor exhibits remarkable sensitivity toward dopamine with a linear range of 6.4 × 10−8–2 × 10−4 M, with a limit of detection as low as 1 × 10−8 M. The proposed method is applied for the determination of dopamine in urine samples by the standard addition route. A range of 1 × 10−7–1 × 10−4 M is obtained from these samples. The relative recoveries are in the range of 95.2%–104%. The proposed method has acceptable performance for the determination of dopamine in real samples with excellent sensitivity and selectivity.
This article describes an up-conversion immunoassay (UCIA) method for the determination of diethylstilbestrol with homogenous and rapid properties. Biotinylated diethylstilbestrol was used as a bridge for the formation of a streptavidinated beads-biotin-diethylstilbestrol‐antibody-acceptor beads complex in the immunoassay. The complex gave out imitation fluorescence at a wavelength of 680 nm when its excitation wavelength was at 615 nm as a result of the generation of singlet oxygen. The optimal test conditions and analytical performance of the method were studied. The optimized reaction time of ≥ 80 min was determined. The best buffer of phosphate buffer containing the surfactant of Tween 20 was established. Additionally, the sound analysis result can be obtained with highest antibody concentration, which was set in the experiments. Calibration curve, fit by 4-parameters formulation, resulted in R2 values of 0.9989, a linear range from 0.025 to 12.5 ng/mL and the limit of detection (LOD) of 0.01 ng/mL. The results of trace diethylstilbestrol concentrations in water samples showed recoveries ranging from 92.0% to 95.0%, and coefficients of variation between 3–8%. The data suggest that UCIA method is a good method with sensitivity for the determination of diethylstilbestrol in water.
1 November 2023 in Journal of the Electrochemical Society
Fenitrothion is a widely prescribed pesticide in agriculture to control penetrating, chewing, and sucking pests on various crops. The electrochemical analytical technique is the obvious choice for establishing a fast, simple, cheap, and sensitive method for fenitrothion analysis. Nickel-iron spinel is an ideal material for electrode modification due to its good electrochemical catalytic properties, high specific surface properties of the nanoparticles, and target trapping ability of the metal hydroxyl sites. Therefore, this work intends to improve the detection of fenitrothion in the environmental matrix by adopting an electrochemical sensor. Herein, NiFe2O4 material was prepared in terms of the hydrothermal synthesis method. Its electrocatalytic performance in fenitrothion detection was evaluated. The synthesized NiFe2O4 was characterized using scanning electron microscopy (SEM), Fourier-transform infrared spectroscopy (FT-IR), and X-ray photoelectron spectroscopy (XPS). The electrocatalytic performance of the electrode modified by NiFe2O4 was studied through cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). It was observed that the fabricated electrochemical sensor based on NiFe2O4 modified electrode exhibited higher electrocatalytic activity towards fenitrothion, resulting in a wide linear range of detection with a low limit of detection (LOD) of 1 × 10−8 mol l−1.