Two kinds of collectors, sodium butyl xanthate and kerosene, and a depressor, sodium sulfide, were used in this research. The study applied flotation tests, pulp potential measurements, contact angle measurements, adsorption calculations, and Fourier Transform Infrared Spectroscopy (FTIR) analyses to demonstrate the correlation between reagents and minerals. For xanthate collectors, the best flotation responses of chalcopyrite and molybdenite were obtained at pH = 8, and, for kerosene, these were obtained at pH = 4. The flotation of molybdenite seemed to be less influenced by xanthate than by kerosene, while that of chalcopyrite showed the opposite. The optimum concentration of sodium sulfide for separation was 0.03 mol/L, which rejected 83% chalcopyrite and recovered 82% molybdenite in the single mineral flotation. Pulp potential measurements revealed that the dixanthogen and xanthate were decomposed and desorbed, respectively, from the mineral surface in a reducing environment. The contact angle measurement and adsorption calculation conformed to the flotation response, indicating that few functions of the xanthate and sodium sulfide on the molybdenite flotation were due to their low adsorption densities. The FTIR results further clarified that the xanthate ion was adsorbed on chalcopyrite by forming cuprous xanthate and dixanthogen; however, on molybdenite the adsorption product was only dixanthogen. After conditioning with sodium sulfide, the chalcopyrite surface became clean, but the molybdenite surface still retained slight peaks of dixanthogen. Meanwhile, the possible mechanism was expounded in this research.
The interaction or nonbonded energies of base organic ions and water molecules during the flotation process of minerals have important meanings for organizing hydrophobic and stable collectors. Furthermore, the interaction, cross-term, and valence energies of optimized structures are important for understanding the properties and structures of selective collectors. The simulation of pure scheelite mineral (PSM) surfaces with four different negative ions, using an adsorption locator module is demonstrated. The interaction energies for base organic ions and water molecules were resolved and detected by shaping the best hydrophobic interaction and the most stable suspension over the PSM surface (112) and (101). The adsorption locator results for base organic ions and water molecules on PSM surfaces (112) and (101) using buffer width 0.5 Å and temperature range from 318.15 to 283.15 K confirmed the results obtain from Forcite calculations. The results have demonstrated that the possibilities of using consistent valence force field implemented by Forcite and adsorption locator modules in the selection of flotation reagents are cost saving. Furthermore, hydrophobicity of the main negative ions in soaps were solved by the simulation methods and results are in a good agreement with the experimental methods that proved that mustard soap is more selective on the mineral surfaces than sunflower soap when used as a collector. Increasing the molecular weight of negative ions increases the interaction energy between base collector ions and PSM surfaces (112) and (101) significantly.