Drops impacting on a flat solid surface will spread until it reaches maximum contact with the substrate underneath. After that, it recoils. In the present work, the variations of energy components during the spreading are studied carefully, including kinetic, capillary, and dissipated energies. Our experimental and numerical results show that, when the impact speed is low, the fast slipping of the contact line (in inertia-capillary regime) and corresponding “interface relaxation” lead to extra dissipation. An auxiliary dissipation is therefore introduced into the traditional theoretical model. The energy components predicted by the improved model agree with the experimental and numerical results very well. As the impact speed increases (the Weber number, , becomes larger than 40 in the present work), the dissipation induced by the initial velocity plays more important roles. The analyses also indicate that on the hydrophobic surfaces the auxiliary dissipation is lower than that on hydrophilic ones. In the later circumstances, the contact angle is larger and the spreading is weaker.
This Letter reports experimental results for partial coalescence when a drop merges with an interface. We find an intermediate range of drop sizes in which the merger is not complete but a daughter drop is left behind. This phenomenon is governed primarily by inertia and interfacial tension, and three regimes can be further delineated depending on the roles of viscosity and gravity. Scaling relationships are developed for the drop size ratio and the coalescence time. For drops that are too large or too small, partial coalescence is arrested by gravity or viscosity, respectively.
Coaxial jet electrospray is a technique to generate microencapsules, which uses electric forces to create a coaxial microjet from two immiscible liquids. Compound droplets with narrow size distribution are produced after the jet breaks up. In this paper, the spraying modes are investigated experimentally with proper flow rates of the inner and outer liquids. Ethanol/glycerol/tween mixture (outer liquid) and cooking oil (inner liquid) are fed into the gap between outer and inner capillaries and the inner capillary, respectively. The spraying modes presented in our experiments are “dripping mode,” “dripping mode in spindle,” “cone-jet mode,” “pulse mode in cone,” and “multijets mode” sequentially, as the applied voltage increases. The region of stable cone-jet mode extends with decrease of the outer liquid flow rate and increase of the inner one. It is found that the spray phenomena are mainly determined by properties of the outer liquid, which is viscous and electric conductive enough. A rudimentary physical model is developed, in which both the viscosity and liquid interface tension are taken into account.
Wetting failure is of vital importance to many physical phenomena, such as industrial coating and drop emission. Here we show when and how the surface roughness promotes the destabilization of a moving contact line on a hydrophilic surface. Beyond the balance of the driving force and viscous resistance where a stable wetting interface is sustained, wetting failure occurs and is modified by the roughness of the surface. The promoting effect arises only when the wetting velocity is high enough to create a gas-liquid-solid composite interface in the vicinity of the moving contact line, and it is a function of the intrinsic contact angle and proportion of solid tops. We propose a model to explain splashes of rough solid spheres impacting into liquids. It reveals a novel concept that dynamic wetting on hydrophilic rough surfaces can be similar to that on hydrophobic surfaces, and brings a new way to design surfaces with specific wetting properties.
1 June 2011 in Computers & Mathematics with Applications