Mojtaba Ashouri

Dr. Mojtaba Ashouri

Shahrood University of Technology, Shāhrūd, Semnān, Iran
orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2014 in Experimental Thermal and Fluid Science
Verified
Journal Article
Closed access
MNMohsen Nazari
Mohsen Nazari
MKM. Karami
M. Karami
MAMojtaba Ashouri
Mojtaba Ashouri

1 February 2015 in International Journal of Thermal Sciences
Verified
Journal Article
Closed access
MNMohsen Nazari
Mohsen Nazari
MAMojtaba Ashouri
Mojtaba Ashouri
MKMohammad Hasan Kayhani
Mohammad Hasan Kayhani
ATAli Tamayol
Ali Tamayol

26 April 2019 in Journal of Thermal Analysis and Calorimetry
Verified
Journal Article
Closed access
PDF file
MNM. Neyestani
M. Neyestani
MNMohsen Nazari
Mohsen Nazari
MSM. M. Shahmardan
M. M. Shahmardan
Mohsen SharifpurMohsen Sharifpur
Mohsen Sharifpur
MAMojtaba Ashouri
Mojtaba Ashouri
JMJ. P. Meyer
J. P. Meyer

1 January 2017 in Applied Thermal Engineering
Verified
Journal Article
Closed access
MNMohsen Nazari
Mohsen Nazari
NBN. Babazadeh Baie
N. Babazadeh Baie
MAMojtaba Ashouri
Mojtaba Ashouri
MSM.M. Shahmardan
M.M. Shahmardan
ATA. Tamayol
A. Tamayol

12 January 2023 in Processes
Verified
Journal Article
Open access
PDF file
MAMojtaba Ashouri
Mojtaba Ashouri
MKMohammadHasan Kayhani
MohammadHasan Kayhani
MNMohsen Nazari
Mohsen Nazari
In this study, the effect of temperature on the velocity and trajectory of a hot sphere falling in a water block was experimentally investigated. The sphere, 12 mm in diameter, was thrown through the water inside an enclosure at the ambient temperature by an electromagnetic attachment mechanism, and the particle velocity was recorded by a high-speed camera at 2000 fps. Then, using an image-processing algorithm, the real-time particle location was extracted and its velocity was measured. The results of the cold sphere falling test were compared with those obtained from the numerical solving by the governing equations. An electric heater was used to heat the sphere up to 100, 200, and 300 °C in order to investigate the effect of temperature on the sphere. The sphere was thrown upon reaching the desired temperature. By increasing the temperature, the sphere’s velocity was increased up to around 40% of the velocity of the cold sphere. Further, the sphere was thrown from a point in the vicinity of the wall to investigate the wall impact on the particle movement. This led the sphere to deviate from its trajectory, with the deviation in the cold sphere being negligible, i.e., around 30% of the sphere’s diameter. However, the rate of deviation was much more notable upon increasing the temperature. The deviation start point varied depending on the sphere’s temperature, with the highest deviation that was observed for a sphere with a temperature of 100 °C. Ultimately, the sphere traveled in a more extended way, with no deviation from the main trajectory, when its temperature was increased.