An accurate evaluation of the shear strength of discontinuities is frequently a key aspect for determining the safety of mining and civil engineering works and for solving instability issues at rock mass scale. This is usually done by using empirical shear strength criteria in which the basic friction angle (φ_b) is a relevant input parameter. Tilt testing is probably the most widespread method to obtain the φ_b due to its simplicity and low cost, but previous research has demonstrated that the results are strongly affected by several factors (e.g. surface finishing, cutting speed, specimen geometry, wear, time and rock type). In this connection, despite it is well known that water significantly reduces the mechanical properties of sedimentary rocks, very scarce research has focused on assessing the impact of the variations in water content on tilt test results. With the aim to fill this gap, saw-cut slabs of three limestone lithotypes were tilt tested in dry state, wet condition (fully water saturated, non-submerged samples) and under exposure to an environmental relative humidity (RH) of 90%. The results revealed that full water saturation caused moderate φ_b reductions in two lithotypes and a φ_b increase in one lithotype. This can be explained by their different microstructure and mineralogy, which makes that lubrication effect prevails over suction effect or vice versa. However, the exposure to a high RH environment did not cause significant φ_b variations. In addition, some important considerations related to tilt testing are provided and discussed, such as the intrinsic variability of the sliding angle (β) and the impact of multiple sliding on the same rock surfaces on β.