This paper examines the effect of structural deformation on the unit slab-type ballastless track structure of high-speed railway. The principle of stationary potential energy was used to map the relation between girder vertical deformation and rail deformation considering the effect of subgrade boundary conditions and the nonlinear contact of interlayer. The theoretical model was verified by comparing with the finite element analysis and experimental results. The theoretical model was used to analyze the effects of several key parameters on the rail deformation, such as vertical deformation amplitude, elastic modulus of the mortar layer, and vertical stiffness of the fasteners. The results show that the track slabs suffered significant disengagement, which makes the deformation of the track structure at the position of the beam joint tend to be gentle when nonlinear contact between the mortar layer and the track slabs was considered. The track slabs disengagement mainly occurs near the beam joints (the side of the deformed beam). As the deflection amplitude of the girder increases, the track deformation, the fastener forces and the disengagement length of the track slabs are obviously nonlinear. When the vertical stiffness of the fastener and/or the elastic modulus of the mortar layer increase, the fastener force and the track plate disengagement length increase monotonically and nonlinearly, which will adversely affect the life and safety of the track structure.
To study the mapping relationship between girder deformation and rail deformation for the CRTS Ⅲ slab ballastless track (SBT) multi-span simply supported bridge, this study derived a simplified analytical solution, and the corresponding ANSYS finite element model (AFEM) was established. Compared with the fine analytical model (FAM) and the AFEM, the calculation results of the three models under the conditions of pier settlement and girder vertical fault were compared, which verified the universal properties of the simplified analytical model (SAM). Based on the verified SAM, the influence of pier settlement, fastener stiffness, girder span, and girder vertical fault on rail deformation was studied. The results show that the rail deformation is approximately proportional to pier settlement and girder vertical fault. With the increase in fastener stiffness, the fastener internal force increases, the rail mapping deformation increases, and the length of the rail mapping deformation area decreases. With the increase in girder span, the rail deformation curve becomes smooth, the length of the rail mapping deformation area becomes longer, and the fastener internal force is significantly reduced.