Moulins are important conduits for surface meltwater to reach the bed of the Greenland Ice Sheet. It has been proposed that in a warming climate, newly formed moulins associated with the inland migration of supraglacial lakes could introduce surface melt to new regions of the bed, introducing or enhancing sliding there. By examining surface strain rates, we found that the upper limit to where crevasses, and therefore moulins, are likely to form is ~1600 m. This is also roughly the elevation above which lakes do not drain completely. Thus, meltwater above this elevation will largely flow tens of kilometers through surface streams into existing moulins downstream. Furthermore, results from a thermal ice sheet model indicate that the ~1600 m crevassing limit is well below the wet‐frozen basal transition (~2000 m). Together, these data sets suggest that new supraglacial lakes will have a limited effect on the inland expansion of melt‐induced seasonal acceleration.
A firn aquifer in the Helheim Glacier catchment of Southeast Greenland lies directly upstream of a crevasse field. Previous measurements show that a 3.5-km long segment of the aquifer lost a large volume of water (26,000 – 65,000 m2 in cross section) between spring 2012 and spring 2013, compared to annual meltwater accumulation of 6000 – 15,000 m2. The water is thought to have entered the crevasses, but whether the water reached the bed or refroze within the ice sheet is unknown. We used a thermo-visco-elastic model for crevasse propagation to calculate the depths and volumes of these water-filled crevasses. We compared our model output to data from the Airborne Topographic Mapper (ATM), which reveals the near-surface geometry of specific crevasses, and WorldView images, which capture the surface expressions of crevasses across our 1.5-km study area. We found a best fit with a shear modulus between 0.2 and 1.5 GPa within our study area. We show that surface meltwater can drive crevasses to the top surface of the firn aquifer (~20 m depth), whereupon it receives water at rates corresponding to the water flux through the aquifer. Our model shows that crevasses receiving firn-aquifer water hydrofracture through to the bed, ~1000 m below, in 10–40 days. Englacial refreezing of firn-aquifer water raises the average local ice temperature by ~4°C over a ten-year period, which enhances deformational ice motion by ~50 m/yr, compared to the observed surface velocity of ~200 m/yr. The effect of the basal water on the sliding velocity remains unknown. Were the firn aquifer not present to concentrate surface meltwater into crevasses, we find that no surface melt would reach the bed; instead, it would refreeze annually in crevasses at depths <500 m. The crevasse field downstream of the firn aquifer likely allows a large fraction of the aquifer water in our study area to reach the bed. Thus, future studies should consider the aquifer and crevasses as part of a common system. This system may uniquely affect ice-sheet dynamics by routing a large volume of water to the bed outside of the typical runoff period.
12 January 2016 in Journal of Geophysical Research: Earth Surface
Resistance at the ice‐bed interface provides a strong control on the response of ice streams and outlet glaciers to external forcing, yet it is not observable by remote sensing. We used inverse methods constrained by satellite observations to infer the basal resistance to flow underneath three of the Greenland Ice Sheet's largest outlet glaciers. In regions of fast ice flow and high (>250 kPa) driving stresses, ice is often assumed to flow over a strong bed. We found, however, that the beds of these three glaciers provide almost no resistance under the fast‐flowing trunk. Instead, resistance to flow is provided by the lateral margins and stronger beds underlying slower‐moving ice upstream. Additionally, we found isolated patches of high basal resistivity within the predominantly weak beds. Because these small‐scale (<1 ice thickness) features may be artifacts of overfitting our solution to measurement errors, we tested their robustness to different degrees of regularization.
A leading hypothesis for the mechanism of fast supraglacial lake drainages is that transient extensional stresses briefly allow crevassing in otherwise compressional ice flow regimes. Lake water can then hydrofracture a crevasse to the base of the ice sheet, and river inputs can maintain this connection as a moulin. If future ice sheet models are to accurately represent moulins, we must understand their formation processes, timescales, and locations. Here, we use remote-sensing velocity products to constrain the relationship between strain rates and lake drainages across ∼ 1600 km2 in Pâkitsoq, western Greenland, between 2002–2019. We find significantly more extensional background strain rates at moulins associated with fast-draining lakes than at slow-draining or non-draining lake moulins. We test whether moulins in more extensional background settings drain their lakes earlier, but we find insignificant correlation. To investigate the frequency at which strain-rate transients are associated with fast lake drainage, we examined Landsat-derived strain rates over 16 and 32 d periods at moulins associated with 240 fast-lake-drainage events over 18 years. A low signal-to-noise ratio, the presence of water, and the multi-week repeat cycle obscured any resolution of the hypothesized transient strain rates. Our results support the hypothesis that transient strain rates drive fast lake drainages. However, the current generation of ice sheet velocity products, even when stacked across hundreds of fast lake drainages, cannot resolve these transients. Thus, observational progress in understanding lake drainage initiation will rely on field-based tools such as GPS networks and photogrammetry.