Herein, the inhibition impacts of chitin, pectin, and amylopectin as carbohydrate polymers on the corrosion of mild steel in 0.5 M HCl were researched utilizing various experimental and theoretical tools. The acquired outcomes showed that the inhibition efficiencies (% IEs) of the tested carbohydrate polymers were increased by raising their concentrations and these biopolymers acting as mixed-kind inhibitors with major anodic ones. The acquired % IEs values were reduced with rising temperature. The higher % IEs of the tested polymers were inferred via powerful adsorption of the polymeric molecules on the steel surface and such adsorption obeyed the Langmuir isotherm. The computed thermodynamic and kinetic quantities confirmed the mechanism of physical adsorption. The kinetics and mechanisms of corrosion and its protection by polymeric compounds were illuminated. The results obtained from all the techniques used confirmed that there was good agreement with each other, and that the % of IEs followed the sequence: chitin > amylopectin > pectin.
Copper is primarily used in many industrial processes, but like many other metals, it suffers from corrosion damage. Polymers are not only one of the effective corrosion inhibitors but also are environmentally friendly agents in doing so. Hence, in this paper, the efficacy of two polyelectrolyte polymers, namely poly(acrylic acid) (PAA) and polyacrylamide (PAM), as corrosion inhibitors for copper in molar nitric acid medium was explored. Chemical, electrochemical, and microscopic tools were employed in this investigation. The weight-loss study revealed that the computed inhibition efficiencies (% IEs) of both PAA and PAM increased with their concentrations but diminished with increasing HNO3 concentration and temperature. The results revealed that, at similar concentrations, the values of % IEs of PAM are slightly higher than those recorded for PAA, where these values at 298 K reached 88% and 84% in the presence of a 250 mg/L of PAM and PAA, respectively. The prominent IE% values for the tested polymers are due to their strong adsorption on the Cu surface and follow the Langmuir adsorption isoform. Thermodynamic and kinetic parameters were also calculated and discussed. The kinetics of corrosion inhibition by PAA and PAM showed a negative first-order process. The results showed also that the used polymers played as mixed-kind inhibitors with anodic priority. The mechanisms of copper corrosion in nitric acid medium and its inhibition by the tested polymers were discussed. DFT calculations and molecular dynamic (MD) modelling were used to investigate the effect of PAA and PAM molecular configuration on their anti-corrosion behavior. The results indicated that the experimental and computational study are highly consistent.
5 April 2023 in Environmental Science and Pollution Research
In this study, the adsorption of methyl red (MR) dye from wastewater on nickel oxide (NiO) doped in porous carbon derived fromHyphaene thebaica(HT) seeds (NiO@HT derived C) as an adsorbent material was investigated.
During the mandatory acidification process in the oil and gas industry, carbon steel unfortunately suffers significant corrosion damage. From this perspective, for the first time a new ionic liquid called 1-(2-(4-bromophenyl)-2-oxoethyl)-4-(tert-butyl)pyridin-1-ium bromide (ILB) has been used as an effective inhibitor for the carbon steel corrosion in aggressive HCl solution (15%) at 298 K. The experiments were managed with a number of different chemical and electrochemical techniques including weight loss, potentiodynamic polarization (PDP), and impedance spectroscopy (EIS). ILB has good inhibitory performance as an acidizing corrosion inhibitor for carbon steel even at low dosing levels of 1 × 10−3 M. The findings were promising as an inhibition efficiency of about 97% was achieved when ILB was added at low concentrations to the corrosive media. EIS results showed a significant rise in charge transfer resistance (Rct) values with increasing doses of ILB. PDP studies confirmed that ILB is a mixed type and obey Langmuir adsorption isotherm with chemical nature. The metal surface morphologies were inspected using a Scanning Electron Microscope (SEM) and an Atomic Force Microscope (AFM). Additionally, Density Functional Theory (DFT) and Molecular Dynamic Simulation (MDS) indicates that ILB molecules function as inhibitors more successfully. There is a high degree of concordance between practical and theoretical studies.
About Me
Central Metallurgical Research & Development Institute, P.O. Box: 87 Helwan,11421, Cairo, Egypt.
Central Metallurgical Research & Development Institute, P.O. Box: 87 Helwan,11421, Cairo, Egypt.