In this paper, a state-of-the-art review on cutting tool technology in machining of Ni-based superalloys is presented to better understand the current status and to identify future directions of research and development of cutting tool technologies. First, past review articles related to the machining of Ni-based superalloys are summarized. Then machinability of superalloys is introduced, together with the reported methods used in cutting tool design. The current researches on cutting tools in the machining of superalloys are presented in different categories in terms of tool materials, i.e., carbide, ceramics, and Polycrystalline cubic boron nitride (PCBN). Moreover, a set of research issues are identified and highlighted to improve the machining of superalloys. Finally, discussions on the future development are presented, in the areas of new materials/geometries, functional surfaces on the cutting tool, and data-driven comprehensive optimization.
12 July 2023 in Robotics and Computer-Integrated Manufacturing
Assembly interface of aircraft vertical tail is a large thin-wall structure and made from titanium alloys, which causes easily machining vibration, deformation and undercutting in finish machining due to its low stiffness, low thermal conductivity, and high chemical activity. To address these problems, a novel eddy current damper for assembly interfaces machining (ECD-AIM) is proposed to suppress multimodal vibration in the machining of the assembly interfaces. Within the context, the mathematical model of damping performance of the damper is established based on the principle of electromagnetic induction, based on which a novel design of the damper is proposed, and optimized by considering the relationship between damping performance and the key components of the damper. Then, the dynamics model of the suppression system of the assembly interface machining is established, where the relationship between vibration velocity and damping performance of the damper is obtained by using numerical analysis and finite element simulation. Finally, the damping performance of the damper is validated in terms of the three configurations (no applied ECD-AIM, a single ECD-AIM, and dual ECD-AIMs) via a set of dynamic tests (impact tests and harmonic tests) and cutting tests. The test results demonstrate that the configuration of dual ECD-AIMs can guarantee stability and reliability of assembly interface machining. The proposed damper can provide a feasible solution for vibration suppression in a limited workspace.