Pentose dehydration and direct transformation of xylan into furfural were performed in a water-cyclopentyl methyl ether (CPME) biphasic system under microwave irradiation. Heated up between 170 and 190 °C in the presence of Nafion NR50 and NaCl, d-xylose, l-arabinose and xylan gave furfural with maximum yields of 80%, 42% and 55%, respectively. The influence of temperature and reaction time on the reaction kinetics was discussed. This study was also completed by the survey of different reactant ratios, such as organic layer-water or catalyst-inorganic salt ratios. The exchange between proton and cation induced by an excess of NaCl was monitored, and a synergetic effect between the remaining protons and the released HCl was also discovered.

Lignocellulosic biomass is a low-cost and environmentally-friendly resource that can be used to produce biofuels such as bioethanol and biogas, which are the leading candidates for the partial substitution of fossil fuels. However, the main challenge of using lignocellulosic materials for biofuel production is the low accessibility to cellulose for hydrolysis of enzymes and microorganisms, which can be overcome by pretreatment. Biological and chemical pretreatments have their own disadvantages, which could be reduced by combining the two methods. In this article, we review biological–chemical combined pretreatment strategies for biogas and bioethanol production. The synergy of fungal/enzyme–NaOH pretreatment is the only biological–chemical combination studied for biogas production and has proven to be effective. The use of enzyme, which is relatively expensive, has the advantage of hydrolysis efficiency compared to fungi. Nonetheless, there is vast scope for research and development of other chemical–biological combinations for biogas production. With respect to ethanol production, fungal–organosolv combination is widely studied and can achieve a maximum of 82% theoretical yield. Order of pretreatment is also important, as fungi may reduce the accessibility of cellulose made available by prior chemical strategies and suppress lignin degradation. The biofuel yield of similarly pretreated biomass can vary depending on the downstream process. Therefore, new strategies, such as bioaugmentation and genetically engineered strains, could help to further intensify biofuel yields.

Straw is a substantial agricultural by-product for biogas production. Hydrolysis of straw is found to be a rate-limiting step during its anaerobic digestion and could be enhanced by pretreatment. In this paper, the effect of various combinations of particle size reduction, autoclaving, and low-level Fenton reaction was studied on straw for biogas production. Grinding of straw contributed to the maximum increase in the biomethane potential. Only Fenton or only the autoclave process improves the kinetics slightly but does not considerably improve the biomethane potential. Combining autoclaving and low-concentration Fenton pretreatment considerably improves the BMP values. Lignin content, CHNSO elemental analysis, Scanning Electronic Microscopy (SEM), Simon’s staining, infrared spectroscopy (DRIFT and ATR), Nuclear magnetic resonance spectroscopy, and wide-angle X-ray diffraction analysis (WAXD) were used to characterize the physical and chemical changes of straw due to pretreatment. Results show a poor correlation between biogas production and the different physical and chemical biomass characteristics. It makes it difficult to explain the outcome of various pretreatment methods applied to biomass. Without further improvement and development of analytical techniques, the prediction of the biomethane potential of a feedstock with the aid of pretreatment can only be considered in case-by-case studies.