To study the landslide risk of high-altitude and cold stope slopes, the slope deformation index and landslide risk standards at home and abroad for many years were analyzed and summarized. Using the unascertained measurement model, combined with the analytic hierarchy process, using the Dongbang slope of the Beizhan Iron Mine in Hejing County, Xinjiang, as the research object, the detailed geological data of the slope were obtained, and nine factors affecting the landslide risk of the slope were analyzed. When calculating the weight of each factor, the actual situation of the slope was used as the standard, and the weight of each factor was determined by the analytic hierarchy process. Then, the undetermined measurement matrix of the slope was determined by the statistical method combined with the expert scoring results. Finally, an unconfirmed measurement model for landslide risk grade evaluation of the Dongbang slope of the Beizhan Iron Mine was formed, and the landslide risk monitoring grade evaluation was carried out on the slope in the cold area. The results show that the landslide risk monitoring level of the Dongbang slope in Beizhan Iron Mine is grade II, which indicates that there is a possibility of mild landslide risk for the slope in this cold area. The research results can provide a reference for the risk level and risk assessment of high-altitude alpine slopes.
The combustion and explosion characteristics of cassava starch and the dispersive physical motion law of dust were systematically studied using a 20 L (=0.02 m3) spherical explosive test device and the numerical simulation method. The experimental results show that the explosion pressure first increases and then decreases with increasing ignition delay time, dust concentration, and spray pressure in the dust storage tank. The maximum explosion pressure was obtained with a dust concentration of 750 g/m3, while the maximum rate of pressure increase was obtained when the concentration was 250 g/m3. The calculated maximum explosion index was 22.3 MPa∙m∙s−1. The simulation results show that the physical movement law of the dust was as follows: high initial velocity → gradual decrease in diffusion velocity → upward linear movement of dust → outward diffusion motion → continuous disorder motion → free settlement → gradual reduction and disorder state → finally, complete settlement. With a powder diffusion time of 120 ms, the dust distribution in the round sphere was the most uniform, which was consistent with the experimental results. After dust ignition, the temperature first gradually increased and then decreased due to heat dissipation. The maximum pressure in the vessel was 46.7 MPa, and the turbulence was the most intense close to the ignition point.