Despite the remarkable capabilities of friction stir welding (FSW) in joining dissimilar materials, the numerical simulation of FSW is predominantly limited to the joining of similar materials. The material mixing and defects’ prediction in FSW of dissimilar materials through numerical simulation have not been thoroughly studied. The role of progressive tool wear is another aspect of practical importance that has not received due consideration in numerical simulation. As such, we contribute to the body of knowledge with a numerical study of FSW of dissimilar materials in the context of defect prediction and tool wear. We numerically simulated material mixing and defects (surface and subsurface tunnel, exit hole, and flash formation) using a coupled Eulerian–Lagrangian approach. The model predictions are validated with the experimental results on FSW of the candidate pair AA6061 and AZ31B. The influence of tool wear on tool dimensions is experimentally investigated for several sets of tool rotations and traverse speeds and incorporated in the numerical simulation to predict the weld defects. The developed model successfully predicted subsurface tunnel defects, surface tunnels, excessive flash formations, and exit holes with a maximum deviation of 1.2 mm. The simulation revealed the substantial impact of the plate position, on either the advancing or retreating side, on the defect formation; for instance, when AZ31B was placed on the AS, the surface tunnel reached about 50% of the workpiece thickness. The numerical model successfully captured defect formation due to the wear-induced changes in tool dimensions, e.g., the pin length decreased up to 30% after welding at higher tool rotations and traverse speeds, leading to surface tunnel defects.
Friction stir welding (FSW) is widely recognized green manufacturing process capable of producing good quality welded joints at a temperature lower than the melting point. However, most of the works are focused on the establishment of the process parameters for a defect-free joint. There is a lack to understand the formation of defects from a physical basis and visualization of the same, which is otherwise difficult to predict by means of simple experiments. The conventional models do not predict chip formation and surface morphology by accounting for the material loss during the process. Hence, a three-dimensional (3D) finite element-based thermomechanical model is developed following coupled Eulerian-Lagrangian (CEL) approach to understand surface morphology by triggering material flow associated with tool–material interaction. In the present quasi-static analysis, the mass scaling factor is explored to make the model computationally feasible by varying the FSW parameter of plunge depth. The simulated results are validated with experimentally measured temperature and surface morphology. In the CEL approach, the material flow out of the workpiece enables the visualization of the chip formation, whereas small deformation predicts the surface quality of the joint.
15 February 2023 in Materials Today Communications
Wire arc additive manufacturing (WAAM) is amongst the emerging technologies of the layer-by-layer deposition process to manufacture the metallic parts. Multi-layer bead deposition using the WAAM process leads to the fabrication of complex products with practical utility. The bead profile of each layer controls the geometry of the final product. However, the melting efficiency and the bead geometry depend on the various process parameters. The primary process parameters affecting the melting efficiency and the bead geometry are the wire feed rate, travel speed, diameter of the wire, and power. Owing to the various complexities during metal deposition, predicting the dimensions at each deposition attribute is not always feasible. Hence, the current work is focused on the utilization of different machine learning (ML) algorithms to understand the relationship between the process parameters, melting efficiency, and bead geometry. The different ML models used for the current work are linear regression (LR), decision tree regressor (DTR), random forest (RF), support vector regression (SVR) and, extra tree regressor (ETR). The ETR is found to predict the melting efficiency with the highest prediction rate of 97.4%, whereas, the SVR and LR predict the bead width and height with the highest accuracy rate of 97.4% and 98.7%, respectively.
18 March 2021 in Arabian Journal for Science and Engineering