The properties of high strength, wear resistance, and high brittleness, make silicon carbide (SiC) materials difficult to process by traditional processing methods. The non-traditional processing method of laser processing has emerged as a viable means of processing silicon carbide materials, as it is very suitable for processing hard and brittle materials, and has the additional advantages of no tool wear, no cutting force, and high processing efficiency. However, in conventional laser processing of silicon carbide, oxidation products occur in the processing area, which can hinder the further removal of the material. To avoid the accumulation of oxidation products and improve the laser processing of the groove structure on the silicon carbide surface, a blowing-assisted laser processing method is proposed by this paper. Comparison experiments between conventional and blowing-assisted laser processing were conducted, in which groove structures of different depths and widths were processed. Two models were established based on the experimental results to explain the material removal process. Finally, the array microgroove structures were successfully processed by blowing-assisted laser processing, verifying the feasibility of improving the laser processing capability of microstructures on silicon carbide surfaces with the assistance of blowing.
To improve the capability of nanosecond lasers to process structures with a high aspect ratio, a new method of nanosecond laser processing in closed flowing water was proposed in this paper. The microgrooves on a stainless steel 304 surface were processed by the new method, and the influence of processing parameters on the microgrooves was studied. The comparative experiments of laser processing in still water and overflowing water were also carried out, and the unusual phenomenon of laser processing in different flowing water was discovered by a high-speed camera. The results showed that the flowing velocity played a crucial role in underwater laser processing, and that high flowing velocity could timely remove bubbles in closed flowing water, thus obtaining higher processing efficiency. As the depth of the groove increased, the bubbles firstly affected the processing of the sidewall, causing a circular transition between the sidewall and bottom surface. The reflection of the laser beam by the bubble could cause secondary processing on the sidewall, resulting in a decrease in the taper angle. Based on the above research, the microgroove with a width of 0.5 mm, aspect ratio of 3, and taper angle of 87.57° was successfully processed by a nanosecond laser in closed flowing water. Compared to conventional nanosecond laser processing, laser processing in closed flowing water was more advantageous in processing microgrooves with a small taper angle and high aspect ratio.