Long-lived luminescence in the blue region was found to occur in deionized water saturated with atmospheric gases following mechanical shaking. Luminescence intensity decreased exponentially after the cessation of stress. During vigorous mechanical shaking, we observed gas bubbles in solution, and the liquid–gas interface area increased noticeably. At the same time, the concentration of molecular oxygen decreased, which could not be attributed to the water warming up with exposure to mechanical stress. However, deaerated water rapidly became saturated with gases following mechanical stress. The recommendation that cell culture media should be mixed after they are removed from the fridge in order to allow saturation with oxygen is probably misleading. It was shown that gases existed in water both in the form of individual molecules and nanobubbles. Mechanical stress did not influence the number or size of nanobubbles. While gas nanobubbles were absent in freshly prepared deaerated water, they appeared following exposure to mechanical stress. In addition, in mechanically treated gas-saturated water, there was seemingly an equilibrium shift towards the decomposition of carbonic acid to water and carbon dioxide. At the same time, the pH of water tended to increase immediately after mechanical stress. It was demonstrated that reactive oxygen species (ROS) form in gas-saturated water under mechanical stress (30 Hz, amplitude of 5 mm). The relative generation rate of hydrogen peroxide and of the hydroxyl radical was 1 nM/min and 0.5 nM/min, respectively. It was found that with an increase in the frequency of mechanical action (f), the rate of ROS generation increased in proportion to f ². The major pathways for hydrogen peroxide generation are probably associated with the formation of singlet oxygen and its further reduction, and the alternative pathway is the formation of hydrogen peroxide as a result of hydroxyl radical recombination.

The influence of laser radiation of a typical surgical laser on the physicochemical properties of the Bovine Serum Albumin (BSA) protein was studied. It was established that the physicochemical characteristics of optical breakdown weakly depend on the concentration of protein molecules. At the same time, the patterns observed for an aqueous solution of BSA irradiated with a laser for different time periods were extremely similar to the classical ones. It was established that after exposure to laser radiation, the optical density of protein solutions increases. At the same time, the intensity of BSA fluorescence due to aromatic amino acid residues decreases insignificantly after exposure to laser radiation. In this case, the position of the excitation and emission maximum does not change, and the shape of the fluorescence spot on 3D maps also does not change significantly. On the Raman spectrum after exposure to laser radiation, a significant decrease in 1570 cm⁻¹ was observed, which indicates the degradation of α-helices and, as a result, partial denaturation of BSA molecules. Partial denaturation did not significantly change the total area of protein molecules, since the refractive index of solutions did not change significantly. However, in BSA solutions, after exposure to laser radiation, the viscosity increased, and the pseudoplasticity of aqueous solutions decreased. In this case, there was no massive damage to the polypeptide chain; on the contrary, when exposed to optical breakdown, intense aggregation was observed, while aggregates with a size of 400 nm or more appeared in the solution. Thus, under the action of optical breakdown induced by laser radiation in a BSA solution, the processes of partial denaturation and aggregation prevail, aromatic amino acid residues are damaged to a lesser extent, and fragmentation of protein molecules is not observed.

In this work the process of optical breakdown under laser irradiation by nanosecond pulses with an energy of 650 mJ of aqueous solutions of Ni nanoparticles is investigated. A monotonic change in the number of breakdowns, the average distance between closest breakdowns, the average plasma size of an individual breakdown, the luminosity of a plasma flash, the intensity of acoustic signals, and the rate of formation of dissociation products—O ₂ , H ₂ , OH ^• , and H ₂ O ₂ with an increase in the irradiation time was established. With an increase in the concentration of nanoparticles, the measured values change non-monotonically. The maximum luminosity of a plasma flash is observed at a nanoparticle concentration of 10 ⁹ NP ml ⁻¹ and 10 ¹⁰ NP ml ⁻¹ and reaches 350 cd m ⁻² . The maximum pressure at the shock front is 1.5–2 MPa at a nanoparticle concentration of 10 ¹⁰ NP ml ⁻¹ . The maximum rates of generation of O ₂ , H ₂ , OH ^• and H ₂ O ₂ are observed at concentrations of 10 ⁹ NP ml ⁻¹ and 10 ¹⁰ NP ml ⁻¹ . Correlation analysis of the studied physicochemical phenomena shows that the formation of molecular gases is associated with acoustic processes, and the formation of radical products and hydrogen peroxide correlates with the physicochemical properties of plasma.

The anti-cancer effects of selenium sources are well known. Among other things, selenium has been shown to have a pleiotropic effect, causing cancer cell death without affecting the healthy cell’s viability, or, in the case of brain cells, has a cytoprotective effect. This feature of selenium determined its use in medicine and its use as part of dietary supplements. In recent years, selenium in the form of nanoparticles has received increased attention. Selenium nanoparticles also have anti-cancer effects, and their use appears to be more effective at significantly lower doses compared to other sources of selenium. The shape and size of nanoparticles largely affect the efficiency of nanoselenium application. We obtained two different types of selenium nanoparticles via the laser ablation technique—spherical selenium nanoparticles (SeNPs) about 100 nm in diameter and grown selenium nanorods (SeNrs) about 1 μm long and about 100 nm thick. We compared the anti-cancer efficacy of these two types of selenium nanoparticles using inhibitory analysis, PCR analysis and fluorescence microscopy. It turned out that both types of nanoparticles with high efficiency dose-dependently activate apoptosis in the human glioblastoma cell line A-172, as the most aggressive type of brain tumor. Apoptosis induction was determined not only by the concentration of nanoparticles, but also by the time. It was shown that SeNrs induce the process of apoptosis in glioblastoma cells more efficiently during 24 h of exposure and their effect is enhanced after 48 h without activation of necrosis, whereas the use of spherical SeNPs after 48 h of exposure can cause necrosis in some glioblastoma cells. It has been shown that Ca²⁺ signals of glioblastoma cells are significantly different for SeNPs and SeNrs. SeNPs cause a dose-dependent transient increase in the number of Ca²⁺ ions in the cell cytosol ([Ca²⁺]_i), while SeNrs cause a slow rise in [Ca²⁺]_i reaching a new stationary level, which may determine the cytotoxic effects of nanoparticles. It turned out that SeNPs and SeNrs cause depletion of the Ca²⁺ depot of the endoplasmic reticulum and ER-stress, which correlates with increased expression of genes encoding proapoptotic proteins. In our study, it was found that SeNPs do not activate the Ca²⁺ signaling system of healthy L-929 mouse fibroblast cells, while SeNrs activate a moderate slow growth in [Ca²⁺]_i. That fact could indicate a lower selectivity of the SeNrs action.

The development of various nanomaterials production technologies has led to the possibility of producing nanoparticles (NPs) and nanostructures, which can find a wide range of applications, from the fabrication of microelectronic devices to the improvement of material properties and the treatment of cancer. The unique characteristics of nanoparticles are primarily due to their small size, which makes size control important in their preparation. Modification of nanoparticles by laser irradiation and obtaining desired nanoparticle properties is a promising approach because of its ease of implementation. The purpose of this review is to analyze the works devoted to the study of laser-induced heating and melting of nanoparticles, to collect information and evaluate the results of using this method for functionalization and modification of metallic nanoparticles, and to discuss promising directions for the use of this technique.