2,3-Butanediol (2,3-BDO) is a synthetic chemical compound that also can be produced by biomass fermentation, which is gaining share in the global market as an intermediate product for numerous applications, i.e. as liquid fuel or fuel additive. Several metabolic engineering fermentation strategies to enhance the production of 2,3-BDO were developed. However, the recovery of 2,3-BDO from its fermentation broth remains a challenge due to its low concentration and its solubility in water and other components. Thus, a cost-effective recovery process is required to deliver the required purity of 2,3-BDO. This paper presents a new process development and techno-economic analysis for 2,3-BDO purification from a fermentation broth. Conventional distillation and hybrid extraction-distillation (HED) processes are proposed in this study with detailed optimization and economic analysis. Particularly, a systematic solvent selection method was successfully implemented to determine a good solvent for the proposed HED configuration based on numerous experimental data obtained with each solvent candidate. NRTL and UNIQUAC property methods were evaluated to obtain binary interaction parameters of 2,3-BDO through rigorous Aspen Plus regression and validated using experimental data. Total annual cost (TAC)-based optimization was performed for each proposed configuration. Even though the HED configuration required 9.5% higher capital cost than conventional distillation, placing an extraction column before the distillation column was effective in removing water from the fermentation broth and significantly improved the overall process economics. Oleyl alcohol was found to be the most suitable solvent for the HED of 2,3-BDO due to its high distribution coefficient and high selectivity. The proposed HED drastically reduced reboiler duty consumption and TAC by up to 54.8 and 25.8%, respectively. The proposed design is expected to be used for the commercial scale of 2,3-BDO production from fermentation process.

Lignocellulosic biomass is one of the most promising alternatives for replacing mineral resources to overcome global warming, which has become the most important environmental issue in recent years. Furfural was listed by the National Renewable Energy Laboratory as one of the top 30 potential chemicals arising from biomass. However, the current production of furfural is energy intensive and uses inefficient technology. Thus, a hybrid purification process that combines extraction and distillation to produce furfural from lignocellulosic biomass was considered and investigated in detail to improve the process efficiency. This effective hybrid process depends on the extracting solvent, which was selected based on a comprehensive procedure that ranged from solvent screening to complete process design. Various solvents were first evaluated in terms of their extraction ability. Then, the most promising solvents were selected to study the separation feasibility. Eventually, processes that used the three best solvents (toluene, benzene, and butyl chloride) were designed and optimized in detail using Aspen Plus. Sustainability analysis was performed to evaluate these processes in terms of their energy requirements, total annual costs (TAC), and carbon dioxide (CO2) emissions. The results showed that butyl chloride was the most suitable solvent for the hybrid furfural process because it could save 44.7% of the TAC while reducing the CO2 emissions by 45.5% compared to the toluene process. In comparison with the traditional purification process using distillation, this suggested hybrid extraction/distillation process can save up to 19.2% of the TAC and reduce 58.3% total annual CO2 emissions. Furthermore, a sensitivity analysis of the feed composition and its effect on the performance of the proposed hybrid system was conducted. Butyl chloride was found to be the most suitable solvent for the hybrid extraction/distillation process of furfural production. The proposed hybrid sequence was more favorable than the traditional distillation process when the methanol fraction of the feed stream was <3% and more benefit could be obtained when that fraction decreased.