The vast majority of perovskite solar cell research has focused on organic–inorganic lead trihalide perovskites; herein, we present working inorganic CsPbI3perovskite solar cells for the first time.
1 September 1999 in The Journal of Physical Chemistry B
We report combined studies of the influence of chemical and physical treatments on the properties of indium–tin oxide (ITO) thin films. The ITO films were also used as transparent anodes of polymeric light-emitting diodes (LEDs) incorporating poly(p-phenylene vinylene) (PPV) as the emitter material, with, or without, doped poly(3,4-ethylene dioxythiophene) (PEDOT) as a hole-injection/transport layer. Structures based on a soluble green derivative of PPV, were also tested. We studied chemical (aquaregia, degreasing, RCA protocol) and physical (oxygen and argon plasmas, Teflon, and paper rubbing) treatments and, in contrast to recently published work, we find that for Balzer Baltracon ITO, oxygen plasma and not aquaregia yields the highest efficiencies and luminances and the lowest drive voltages. For oxygen-plasma-treated anodes, the device efficiency clearly correlates with the value of the ITO surface work function, which in turn depends on the time of treatment. Interestingly, we find that work-function variations induced by our oxygen-plasma treatment are unchanged after long-term storage in air and in the dark. Unexpectedly, we also find that devices incorporating a PEDOT layer benefit from an appropriate treatment of the ITO surface, for both efficiency and lifetime. The results shed light on the physics of conjugated, organic semiconductors and related devices, and in particular on the presence and the role of an anodic energy barrier on the LEDs mechanism of operation. We also discuss the implications of our integrated experimental study in relation to the modification of the ITO sheet resistance, surface and bulk composition, and surface morphology.
We report electroabsorption measurements of polymer light-emitting diodes, (LEDs), fabricated with poly(4-4′-diphenylene diphenylvinylene), PDPV, as the emissive layer, Ca–Al cathodes, and indium tin oxide (ITO) anodes, with and without a doped conducting polymer hole injection/transport layer, namely poly(3,4-ethylene dioxythiophene), PEDOT, doped with poly(styrene sulfonate), PSS−. In these structures, the bias at which the electroabsorption signal is null corresponds to the difference between the electrodes’ work functions. We find that such a built-in voltage increases by 0.5 V when a PEDOT:PSS film is incorporated between the ITO electrode and the emissive layer. This leads to a marked reduction of the anode barrier height at the hole-injecting interface, and accounts for a variety of improvements brought about by the PEDOT insertion, namely: (a) the increase of luminescence efficiency, (b) the reduction of the turn-on voltage, and (c) the increase of the device lifetime.